| This document describes how to upload the cx2341x firmware to the card. |
| |
| How to find |
| =========== |
| |
| See the web pages of the various projects that uses this chip for information |
| on how to obtain the firmware. |
| |
| The firmware stored in a Windows driver can be detected as follows: |
| |
| - Each firmware image is 256k bytes. |
| - The 1st 32-bit word of the Encoder image is 0x0000da7 |
| - The 1st 32-bit word of the Decoder image is 0x00003a7 |
| - The 2nd 32-bit word of both images is 0xaa55bb66 |
| |
| How to load |
| =========== |
| |
| - Issue the FWapi command to stop the encoder if it is running. Wait for the |
| command to complete. |
| - Issue the FWapi command to stop the decoder if it is running. Wait for the |
| command to complete. |
| - Issue the I2C command to the digitizer to stop emitting VSYNC events. |
| - Issue the FWapi command to halt the encoder's firmware. |
| - Sleep for 10ms. |
| - Issue the FWapi command to halt the decoder's firmware. |
| - Sleep for 10ms. |
| - Write 0x00000000 to register 0x2800 to stop the Video Display Module. |
| - Write 0x00000005 to register 0x2D00 to stop the AO (audio output?). |
| - Write 0x00000000 to register 0xA064 to ping? the APU. |
| - Write 0xFFFFFFFE to register 0x9058 to stop the VPU. |
| - Write 0xFFFFFFFF to register 0x9054 to reset the HW blocks. |
| - Write 0x00000001 to register 0x9050 to stop the SPU. |
| - Sleep for 10ms. |
| - Write 0x0000001A to register 0x07FC to init the Encoder SDRAM's pre-charge. |
| - Write 0x80000640 to register 0x07F8 to init the Encoder SDRAM's refresh to 1us. |
| - Write 0x0000001A to register 0x08FC to init the Decoder SDRAM's pre-charge. |
| - Write 0x80000640 to register 0x08F8 to init the Decoder SDRAM's refresh to 1us. |
| - Sleep for 512ms. (600ms is recommended) |
| - Transfer the encoder's firmware image to offset 0 in Encoder memory space. |
| - Transfer the decoder's firmware image to offset 0 in Decoder memory space. |
| - Use a read-modify-write operation to Clear bit 0 of register 0x9050 to |
| re-enable the SPU. |
| - Sleep for 1 second. |
| - Use a read-modify-write operation to Clear bits 3 and 0 of register 0x9058 |
| to re-enable the VPU. |
| - Sleep for 1 second. |
| - Issue status API commands to both firmware images to verify. |
| |