be2net: Changes to update ethtool get_settings function to return appropriate values.
Update ethtool get_settings function to:
- get current link speed settings from controller
- get port transceiver type from controller
- fill appropriate values for supported, phy_address
Signed-off-by: Sarveshwar Bandi <sarveshwarb@serverengines.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/benet/be_ethtool.c b/drivers/net/benet/be_ethtool.c
index 280471e..edebce9 100644
--- a/drivers/net/benet/be_ethtool.c
+++ b/drivers/net/benet/be_ethtool.c
@@ -293,9 +293,43 @@
static int be_get_settings(struct net_device *netdev, struct ethtool_cmd *ecmd)
{
- ecmd->speed = SPEED_10000;
+ struct be_adapter *adapter = netdev_priv(netdev);
+ u8 mac_speed = 0, connector = 0;
+ u16 link_speed = 0;
+ bool link_up = false;
+
+ be_cmd_link_status_query(adapter, &link_up, &mac_speed, &link_speed);
+
+ /* link_speed is in units of 10 Mbps */
+ if (link_speed) {
+ ecmd->speed = link_speed*10;
+ } else {
+ switch (mac_speed) {
+ case PHY_LINK_SPEED_1GBPS:
+ ecmd->speed = SPEED_1000;
+ break;
+ case PHY_LINK_SPEED_10GBPS:
+ ecmd->speed = SPEED_10000;
+ break;
+ }
+ }
ecmd->duplex = DUPLEX_FULL;
ecmd->autoneg = AUTONEG_DISABLE;
+ ecmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_TP);
+
+ be_cmd_read_port_type(adapter, adapter->port_num, &connector);
+ switch (connector) {
+ case 7:
+ ecmd->port = PORT_FIBRE;
+ break;
+ default:
+ ecmd->port = PORT_TP;
+ break;
+ }
+
+ ecmd->phy_address = adapter->port_num;
+ ecmd->transceiver = XCVR_INTERNAL;
+
return 0;
}