mac80211: Fix HT channel selection
HT management is done differently for AP and STA modes, unify
to just the ->config() callback since HT is fundamentally a
PHY property and cannot be per-BSS.
Rename enum nl80211_sec_chan_offset as nl80211_channel_type to denote
the channel type ( NO_HT, HT20, HT40+, HT40- ).
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: Sujith <Sujith.Manoharan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 046ce69..22ae72c 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -165,14 +165,9 @@
/**
* struct ieee80211_bss_ht_conf - BSS's changing HT configuration
- * @secondary_channel_offset: secondary channel offset, uses
- * %IEEE80211_HT_PARAM_CHA_SEC_ values
- * @width_40_ok: indicates that 40 MHz bandwidth may be used for TX
* @operation_mode: HT operation mode (like in &struct ieee80211_ht_info)
*/
struct ieee80211_bss_ht_conf {
- u8 secondary_channel_offset;
- bool width_40_ok;
u16 operation_mode;
};
@@ -508,9 +503,7 @@
struct ieee80211_ht_conf {
bool enabled;
- int sec_chan_offset; /* 0 = HT40 disabled; -1 = HT40 enabled, secondary
- * channel below primary; 1 = HT40 enabled,
- * secondary channel above primary */
+ enum nl80211_channel_type channel_type;
};
/**