ARM: OMAP: use gpio_to_irq
Have most uses of OMAP_GPIO_IRQ() use gpio_to_irq() instead.
Calls used for table initialization are left alone, at least
this time around.
(This patch is for code in both the OMAP tree and mainline.)
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap1/board-osk.c b/arch/arm/mach-omap1/board-osk.c
index 3e766e4..2f88095 100644
--- a/arch/arm/mach-omap1/board-osk.c
+++ b/arch/arm/mach-omap1/board-osk.c
@@ -288,7 +288,7 @@
return;
}
/* the CF I/O IRQ is really active-low */
- set_irq_type(OMAP_GPIO_IRQ(62), IRQ_TYPE_EDGE_FALLING);
+ set_irq_type(gpio_to_irq(62), IRQ_TYPE_EDGE_FALLING);
}
static void __init osk_init_irq(void)
@@ -483,7 +483,7 @@
omap_cfg_reg(P20_1610_GPIO4); /* PENIRQ */
gpio_request(4, "ts_int");
gpio_direction_input(4);
- set_irq_type(OMAP_GPIO_IRQ(4), IRQ_TYPE_EDGE_FALLING);
+ set_irq_type(gpio_to_irq(4), IRQ_TYPE_EDGE_FALLING);
spi_register_board_info(mistral_boardinfo,
ARRAY_SIZE(mistral_boardinfo));
@@ -492,14 +492,15 @@
omap_cfg_reg(N15_1610_MPUIO2);
if (gpio_request(OMAP_MPUIO(2), "wakeup") == 0) {
int ret = 0;
+ int irq = gpio_to_irq(OMAP_MPUIO(2));
gpio_direction_input(OMAP_MPUIO(2));
- set_irq_type(OMAP_GPIO_IRQ(OMAP_MPUIO(2)), IRQ_TYPE_EDGE_RISING);
+ set_irq_type(irq, IRQ_TYPE_EDGE_RISING);
#ifdef CONFIG_PM
/* share the IRQ in case someone wants to use the
* button for more than wakeup from system sleep.
*/
- ret = request_irq(OMAP_GPIO_IRQ(OMAP_MPUIO(2)),
+ ret = request_irq(irq,
&osk_mistral_wake_interrupt,
IRQF_SHARED, "mistral_wakeup",
&osk_mistral_wake_interrupt);
@@ -508,7 +509,7 @@
printk(KERN_ERR "OSK+Mistral: no wakeup irq, %d?\n",
ret);
} else
- enable_irq_wake(OMAP_GPIO_IRQ(OMAP_MPUIO(2)));
+ enable_irq_wake(irq);
#endif
} else
printk(KERN_ERR "OSK+Mistral: wakeup button is awol\n");