amba pl011: platform data for reg lockup and glitch v2
This patch provides platform data for following
- uart reset function to assist uart register lockup workaround
- init/exit function to fix glitch in the tx pin in tty_open
when tty port0 is opened a glitch is seen in the tx line
of uart0. This happens in pl011_startup() when tx fifo
interrupt is provoked into asserting.
Now uart0 pins are enabled (alt function) only when init
is complete and turned back to gpio when closed.
Signed-off-by: Shreshtha Kumar Sahu <shreshthakumar.sahu@stericsson.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/arch/arm/mach-ux500/board-mop500-pins.c b/arch/arm/mach-ux500/board-mop500-pins.c
index fd4cf1c..70cdbd6 100644
--- a/arch/arm/mach-ux500/board-mop500-pins.c
+++ b/arch/arm/mach-ux500/board-mop500-pins.c
@@ -110,10 +110,18 @@
GPIO168_KP_O0,
/* UART */
- GPIO0_U0_CTSn | PIN_INPUT_PULLUP,
- GPIO1_U0_RTSn | PIN_OUTPUT_HIGH,
- GPIO2_U0_RXD | PIN_INPUT_PULLUP,
- GPIO3_U0_TXD | PIN_OUTPUT_HIGH,
+ /* uart-0 pins gpio configuration should be
+ * kept intact to prevent glitch in tx line
+ * when tty dev is opened. Later these pins
+ * are configured to uart mop500_pins_uart0
+ *
+ * It will be replaced with uart configuration
+ * once the issue is solved.
+ */
+ GPIO0_GPIO | PIN_INPUT_PULLUP,
+ GPIO1_GPIO | PIN_OUTPUT_HIGH,
+ GPIO2_GPIO | PIN_INPUT_PULLUP,
+ GPIO3_GPIO | PIN_OUTPUT_HIGH,
GPIO29_U2_RXD | PIN_INPUT_PULLUP,
GPIO30_U2_TXD | PIN_OUTPUT_HIGH,