powerpc/booke: Clean up the hardware watchpoint support
* CONFIG_BOOKE is selected by CONFIG_44x so we dont need both
* Fixed a few comments
* Go back to only using DBCR0_IDM to determine if we are using
debug resources.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
diff --git a/arch/powerpc/kernel/ptrace.c b/arch/powerpc/kernel/ptrace.c
index a5d0e78..66204cb 100644
--- a/arch/powerpc/kernel/ptrace.c
+++ b/arch/powerpc/kernel/ptrace.c
@@ -717,7 +717,7 @@
struct pt_regs *regs = task->thread.regs;
-#if defined(CONFIG_44x) || defined(CONFIG_BOOKE)
+#if defined(CONFIG_BOOKE)
/* If DAC then do not single step, skip */
if (task->thread.dabr)
return;
@@ -744,10 +744,11 @@
if (addr > 0)
return -EINVAL;
+ /* The bottom 3 bits in dabr are flags */
if ((data & ~0x7UL) >= TASK_SIZE)
return -EIO;
-#ifdef CONFIG_PPC64
+#ifndef CONFIG_BOOKE
/* For processors using DABR (i.e. 970), the bottom 3 bits are flags.
* It was assumed, on previous implementations, that 3 bits were
@@ -769,7 +770,7 @@
task->thread.dabr = data;
#endif
-#if defined(CONFIG_44x) || defined(CONFIG_BOOKE)
+#if defined(CONFIG_BOOKE)
/* As described above, it was assumed 3 bits were passed with the data
* address, but we will assume only the mode bits will be passed