nl80211: Add probe response offload attribute
Notify user-space about probe-response offloading support in the driver.
A wiphy flag is used to indicate support and a bitmap of protocols
determines which protocols are supported.
Change-Id: I13b16c71449ab61f4308b6caa1cca35529f905b4
Signed-off-by: Deepthi Gowri <deepthi@codeaurora.org>
diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h
index 68ac002..53c7196 100644
--- a/include/net/cfg80211.h
+++ b/include/net/cfg80211.h
@@ -1594,6 +1594,11 @@
* command. When this flag is not set, @NL80211_CMD_TDLS_OPER should be
* used for asking the driver/firmware to perform a TDLS operation.
* @WIPHY_FLAG_HAVE_AP_SME: device integrates AP SME
+ * @WIPHY_FLAG_REPORTS_OBSS: the device will report beacons from other BSSes
+ * when there are virtual interfaces in AP mode by calling
+ * cfg80211_report_obss_beacon().
+ * @WIPHY_FLAG_AP_PROBE_RESP_OFFLOAD: When operating as an AP, the device
+ * responds to probe-requests in hardware.
*/
enum wiphy_flags {
WIPHY_FLAG_CUSTOM_REGULATORY = BIT(0),
@@ -1613,6 +1618,8 @@
WIPHY_FLAG_SUPPORTS_TDLS = BIT(15),
WIPHY_FLAG_TDLS_EXTERNAL_SETUP = BIT(16),
WIPHY_FLAG_HAVE_AP_SME = BIT(17),
+ WIPHY_FLAG_REPORTS_OBSS = BIT(18),
+ WIPHY_FLAG_AP_PROBE_RESP_OFFLOAD = BIT(19),
};
/**
@@ -1856,6 +1863,13 @@
u32 available_antennas_tx;
u32 available_antennas_rx;
+ /*
+ * Bitmap of supported protocols for probe response offloading
+ * see &enum nl80211_probe_resp_offload_support_attr. Only valid
+ * when the wiphy flag @WIPHY_FLAG_AP_PROBE_RESP_OFFLOAD is set.
+ */
+ u32 probe_resp_offload;
+
/* If multiple wiphys are registered and you're handed e.g.
* a regular netdev with assigned ieee80211_ptr, you won't
* know whether it points to a wiphy your driver has registered