igb: Add support of SerDes Forced mode for certain hardware
This patch changes the serdes link code to support a forced mode for
some hardware, based on bit set in EEPROM.
Signed-off-by: Carolyn Wyborny <carolyn.wyborny@intel.com>
Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/igb/e1000_82575.c b/drivers/net/igb/e1000_82575.c
index 7b7e157..c0857bd 100644
--- a/drivers/net/igb/e1000_82575.c
+++ b/drivers/net/igb/e1000_82575.c
@@ -1156,10 +1156,13 @@
{
u32 ctrl_ext, ctrl_reg, reg;
bool pcs_autoneg;
+ s32 ret_val = E1000_SUCCESS;
+ u16 data;
if ((hw->phy.media_type != e1000_media_type_internal_serdes) &&
!igb_sgmii_active_82575(hw))
- return 0;
+ return ret_val;
+
/*
* On the 82575, SerDes loopback mode persists until it is
@@ -1203,6 +1206,18 @@
/* disable PCS autoneg and support parallel detect only */
pcs_autoneg = false;
default:
+ if (hw->mac.type == e1000_82575 ||
+ hw->mac.type == e1000_82576) {
+ ret_val = hw->nvm.ops.read(hw, NVM_COMPAT, 1, &data);
+ if (ret_val) {
+ printk(KERN_DEBUG "NVM Read Error\n\n");
+ return ret_val;
+ }
+
+ if (data & E1000_EEPROM_PCS_AUTONEG_DISABLE_BIT)
+ pcs_autoneg = false;
+ }
+
/*
* non-SGMII modes only supports a speed of 1000/Full for the
* link so it is best to just force the MAC and let the pcs
@@ -1250,7 +1265,7 @@
if (!igb_sgmii_active_82575(hw))
igb_force_mac_fc(hw);
- return 0;
+ return ret_val;
}
/**