ixgbe: fix initial interrupt throttle settings
ixgbe was incorrectly setting the throttle rate setting for all tx
queues and the driver has been refreshed to better handle a dynamic
interrupt mode as well as multiple queues.
Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/net/ixgbe/ixgbe_main.c b/drivers/net/ixgbe/ixgbe_main.c
index 0269115..ef965c9 100644
--- a/drivers/net/ixgbe/ixgbe_main.c
+++ b/drivers/net/ixgbe/ixgbe_main.c
@@ -744,12 +744,12 @@
r_idx + 1);
}
- /* if this is a tx only vector use half the irq (tx) rate */
+ /* if this is a tx only vector halve the interrupt rate */
if (q_vector->txr_count && !q_vector->rxr_count)
- q_vector->eitr = adapter->tx_eitr;
+ q_vector->eitr = (adapter->eitr_param >> 1);
else
- /* rx only or mixed */
- q_vector->eitr = adapter->rx_eitr;
+ /* rx only */
+ q_vector->eitr = adapter->eitr_param;
IXGBE_WRITE_REG(&adapter->hw, IXGBE_EITR(v_idx),
EITR_INTS_PER_SEC_TO_REG(q_vector->eitr));
@@ -845,13 +845,13 @@
for (i = 0; i < q_vector->txr_count; i++) {
tx_ring = &(adapter->tx_ring[r_idx]);
ret_itr = ixgbe_update_itr(adapter, q_vector->eitr,
- q_vector->tx_eitr,
+ q_vector->tx_itr,
tx_ring->total_packets,
tx_ring->total_bytes);
/* if the result for this queue would decrease interrupt
* rate for this vector then use that result */
- q_vector->tx_eitr = ((q_vector->tx_eitr > ret_itr) ?
- q_vector->tx_eitr - 1 : ret_itr);
+ q_vector->tx_itr = ((q_vector->tx_itr > ret_itr) ?
+ q_vector->tx_itr - 1 : ret_itr);
r_idx = find_next_bit(q_vector->txr_idx, adapter->num_tx_queues,
r_idx + 1);
}
@@ -860,18 +860,18 @@
for (i = 0; i < q_vector->rxr_count; i++) {
rx_ring = &(adapter->rx_ring[r_idx]);
ret_itr = ixgbe_update_itr(adapter, q_vector->eitr,
- q_vector->rx_eitr,
+ q_vector->rx_itr,
rx_ring->total_packets,
rx_ring->total_bytes);
/* if the result for this queue would decrease interrupt
* rate for this vector then use that result */
- q_vector->rx_eitr = ((q_vector->rx_eitr > ret_itr) ?
- q_vector->rx_eitr - 1 : ret_itr);
+ q_vector->rx_itr = ((q_vector->rx_itr > ret_itr) ?
+ q_vector->rx_itr - 1 : ret_itr);
r_idx = find_next_bit(q_vector->rxr_idx, adapter->num_rx_queues,
r_idx + 1);
}
- current_itr = max(q_vector->rx_eitr, q_vector->tx_eitr);
+ current_itr = max(q_vector->rx_itr, q_vector->tx_itr);
switch (current_itr) {
/* counts and packets in update_itr are dependent on these numbers */
@@ -970,16 +970,24 @@
struct ixgbe_adapter *adapter = q_vector->adapter;
struct ixgbe_ring *rx_ring;
int r_idx;
+ int i;
r_idx = find_first_bit(q_vector->rxr_idx, adapter->num_rx_queues);
+ for (i = 0; i < q_vector->rxr_count; i++) {
+ rx_ring = &(adapter->rx_ring[r_idx]);
+ rx_ring->total_bytes = 0;
+ rx_ring->total_packets = 0;
+ r_idx = find_next_bit(q_vector->rxr_idx, adapter->num_rx_queues,
+ r_idx + 1);
+ }
+
if (!q_vector->rxr_count)
return IRQ_HANDLED;
+ r_idx = find_first_bit(q_vector->rxr_idx, adapter->num_rx_queues);
rx_ring = &(adapter->rx_ring[r_idx]);
/* disable interrupts on this vector only */
IXGBE_WRITE_REG(&adapter->hw, IXGBE_EIMC, rx_ring->v_idx);
- rx_ring->total_bytes = 0;
- rx_ring->total_packets = 0;
netif_rx_schedule(adapter->netdev, &q_vector->napi);
return IRQ_HANDLED;
@@ -1020,7 +1028,7 @@
/* If all Rx work done, exit the polling mode */
if (work_done < budget) {
netif_rx_complete(adapter->netdev, napi);
- if (adapter->rx_eitr < IXGBE_MIN_ITR_USECS)
+ if (adapter->itr_setting & 3)
ixgbe_set_itr_msix(q_vector);
if (!test_bit(__IXGBE_DOWN, &adapter->state))
IXGBE_WRITE_REG(&adapter->hw, IXGBE_EIMS, rx_ring->v_idx);
@@ -1187,16 +1195,16 @@
struct ixgbe_ring *rx_ring = &adapter->rx_ring[0];
struct ixgbe_ring *tx_ring = &adapter->tx_ring[0];
- q_vector->tx_eitr = ixgbe_update_itr(adapter, new_itr,
- q_vector->tx_eitr,
- tx_ring->total_packets,
- tx_ring->total_bytes);
- q_vector->rx_eitr = ixgbe_update_itr(adapter, new_itr,
- q_vector->rx_eitr,
- rx_ring->total_packets,
- rx_ring->total_bytes);
+ q_vector->tx_itr = ixgbe_update_itr(adapter, new_itr,
+ q_vector->tx_itr,
+ tx_ring->total_packets,
+ tx_ring->total_bytes);
+ q_vector->rx_itr = ixgbe_update_itr(adapter, new_itr,
+ q_vector->rx_itr,
+ rx_ring->total_packets,
+ rx_ring->total_bytes);
- current_itr = max(q_vector->rx_eitr, q_vector->tx_eitr);
+ current_itr = max(q_vector->rx_itr, q_vector->tx_itr);
switch (current_itr) {
/* counts and packets in update_itr are dependent on these numbers */
@@ -1371,7 +1379,7 @@
struct ixgbe_hw *hw = &adapter->hw;
IXGBE_WRITE_REG(hw, IXGBE_EITR(0),
- EITR_INTS_PER_SEC_TO_REG(adapter->rx_eitr));
+ EITR_INTS_PER_SEC_TO_REG(adapter->eitr_param));
ixgbe_set_ivar(adapter, IXGBE_IVAR_RX_QUEUE(0), 0);
ixgbe_set_ivar(adapter, IXGBE_IVAR_TX_QUEUE(0), 0);
@@ -2209,7 +2217,7 @@
/* If budget not fully consumed, exit the polling mode */
if (work_done < budget) {
netif_rx_complete(adapter->netdev, napi);
- if (adapter->rx_eitr < IXGBE_MIN_ITR_USECS)
+ if (adapter->itr_setting & 3)
ixgbe_set_itr(adapter);
if (!test_bit(__IXGBE_DOWN, &adapter->state))
ixgbe_irq_enable(adapter);
@@ -2421,12 +2429,6 @@
int vector, v_budget;
/*
- * Set the default interrupt throttle rate.
- */
- adapter->rx_eitr = (1000000 / IXGBE_DEFAULT_ITR_RX_USECS);
- adapter->tx_eitr = (1000000 / IXGBE_DEFAULT_ITR_TX_USECS);
-
- /*
* It's easy to be greedy for MSI-X vectors, but it really
* doesn't do us much good if we have a lot more vectors
* than CPU's. So let's be conservative and only ask for
@@ -2567,10 +2569,6 @@
adapter->ring_feature[RING_F_RSS].indices = rss;
adapter->flags |= IXGBE_FLAG_RSS_ENABLED;
- /* Enable Dynamic interrupt throttling by default */
- adapter->rx_eitr = 1;
- adapter->tx_eitr = 1;
-
/* default flow control settings */
hw->fc.original_type = ixgbe_fc_none;
hw->fc.type = ixgbe_fc_none;
@@ -2591,6 +2589,18 @@
return -EIO;
}
+ /* enable itr by default in dynamic mode */
+ adapter->itr_setting = 1;
+ adapter->eitr_param = 20000;
+
+ /* set defaults for eitr in MegaBytes */
+ adapter->eitr_low = 10;
+ adapter->eitr_high = 20;
+
+ /* set default ring sizes */
+ adapter->tx_ring_count = IXGBE_DEFAULT_TXD;
+ adapter->rx_ring_count = IXGBE_DEFAULT_RXD;
+
/* initialize eeprom parameters */
if (ixgbe_init_eeprom(hw)) {
dev_err(&pdev->dev, "EEPROM initialization failed\n");