msm: 8960: set SDC1 CMD and DATA line to pull up state during LPM
Keeping CMD and DATA lines pull configuration to PULL UP will
make sure that there is no leakage current during sleep if
external pull up is connected to any of these lines.
CRs-fixed: 332254
Change-Id: I99571f5cac10ead6e5744a8d5deb7bad4f7a8a3b
Signed-off-by: Subhash Jadavani <subhashj@codeaurora.org>
diff --git a/arch/arm/mach-msm/board-8960-storage.c b/arch/arm/mach-msm/board-8960-storage.c
index 8b43d38..4e4d26ef 100644
--- a/arch/arm/mach-msm/board-8960-storage.c
+++ b/arch/arm/mach-msm/board-8960-storage.c
@@ -121,8 +121,8 @@
static struct msm_mmc_pad_pull sdc1_pad_pull_off_cfg[] = {
{TLMM_PULL_SDC1_CLK, GPIO_CFG_NO_PULL},
- {TLMM_PULL_SDC1_CMD, GPIO_CFG_PULL_DOWN},
- {TLMM_PULL_SDC1_DATA, GPIO_CFG_PULL_DOWN}
+ {TLMM_PULL_SDC1_CMD, GPIO_CFG_PULL_UP},
+ {TLMM_PULL_SDC1_DATA, GPIO_CFG_PULL_UP}
};
/* SDC3 pad data */