imxmmc: move RSSR BLR
DMA request source (RSSR) needs to be set only once (in probe).
DMA burst length (BLR) need to be set only in set_ios()
This cleans up imxmci_setup_data() and should make it a little
bit faster :)
Signed-off-by: Paulius Zaleckas <paulius.zaleckas@teltonika.lt>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
diff --git a/drivers/mmc/host/imxmmc.c b/drivers/mmc/host/imxmmc.c
index 0fa7af3..e0be21a 100644
--- a/drivers/mmc/host/imxmmc.c
+++ b/drivers/mmc/host/imxmmc.c
@@ -307,13 +307,6 @@
wmb();
- if (host->actual_bus_width == MMC_BUS_WIDTH_4)
- BLR(host->dma) = 0; /* burst 64 byte read / 64 bytes write */
- else
- BLR(host->dma) = 16; /* burst 16 byte read / 16 bytes write */
-
- RSSR(host->dma) = DMA_REQ_SDHC;
-
set_bit(IMXMCI_PEND_DMA_DATA_b, &host->pending_events);
clear_bit(IMXMCI_PEND_CPU_DATA_b, &host->pending_events);
@@ -818,9 +811,11 @@
if (ios->bus_width == MMC_BUS_WIDTH_4) {
host->actual_bus_width = MMC_BUS_WIDTH_4;
imx_gpio_mode(PB11_PF_SD_DAT3);
+ BLR(host->dma) = 0; /* burst 64 byte read/write */
} else {
host->actual_bus_width = MMC_BUS_WIDTH_1;
imx_gpio_mode(GPIO_PORTB | GPIO_IN | GPIO_PUEN | 11);
+ BLR(host->dma) = 16; /* burst 16 byte read/write */
}
if (host->power_mode != ios->power_mode) {
@@ -1034,6 +1029,7 @@
}
host->dma_allocated = 1;
imx_dma_setup_handlers(host->dma, imxmci_dma_irq, NULL, host);
+ RSSR(host->dma) = DMA_REQ_SDHC;
tasklet_init(&host->tasklet, imxmci_tasklet_fnc, (unsigned long)host);
host->status_reg=0;