stmmac: unify MAC and PHY configuration parameters (V2)
Prior to this change, most PHY configuration parameters were passed
into the STMMAC device as a separate PHY device. As well as being
unusual, this made it difficult to make changes to the MAC/PHY
relationship.
This patch moves all the PHY parameters into the MAC configuration
structure, mainly as a separate structure. This allows us to completely
ignore the MDIO bus attached to a stmmac if desired, and not create
the PHY bus. It also allows the stmmac driver to use a different PHY
from the one it is connected to, for example a fixed PHY or bit banging
PHY.
Also derive the stmmac/PHY connection type (MII/RMII etc) from the
mode can be passed into <platf>_configure_ethernet.
STLinux kernel at git://git.stlinux.com/stm/linux-sh4-2.6.32.y.git
provides several examples how to use this new infrastructure (that
actually is easier to maintain and clearer).
Signed-off-by: Stuart Menefy <stuart.menefy@st.com>
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/include/linux/stmmac.h b/include/linux/stmmac.h
index 05d7756..0dddc9e 100644
--- a/include/linux/stmmac.h
+++ b/include/linux/stmmac.h
@@ -28,11 +28,21 @@
#include <linux/platform_device.h>
-/* platform data for platform device structure's platform_data field */
+/* Platfrom data for platform device structure's platform_data field */
-/* Private data for the STM on-board ethernet driver */
+struct stmmac_mdio_bus_data {
+ int bus_id;
+ int (*phy_reset)(void *priv);
+ unsigned int phy_mask;
+ int *irqs;
+ int probed_phy_irq;
+};
+
struct plat_stmmacenet_data {
int bus_id;
+ int phy_addr;
+ int interface;
+ struct stmmac_mdio_bus_data *mdio_bus_data;
int pbl;
int clk_csr;
int has_gmac;
@@ -48,14 +58,4 @@
void *custom_cfg;
void *bsp_priv;
};
-
-struct plat_stmmacphy_data {
- int bus_id;
- int phy_addr;
- unsigned int phy_mask;
- int interface;
- int (*phy_reset)(void *priv);
- void *priv;
-};
#endif
-