[ARM] Kirkwood: add support for L2 cache WB/WT selection
Feroceon L2 cache can work in eighther write through or write back mode
on Kirkwood. Add the option to configure this mode according to Kconfig.
Signed-off-by: Ronen Shitrit <rshitrit@marvell.com>
Signed-off-by: Nicolas Pitre <nico@marvell.com>
diff --git a/arch/arm/mm/proc-feroceon.S b/arch/arm/mm/proc-feroceon.S
index f2e5884..207392f 100644
--- a/arch/arm/mm/proc-feroceon.S
+++ b/arch/arm/mm/proc-feroceon.S
@@ -80,7 +80,8 @@
msr cpsr_c, ip
bl feroceon_flush_kern_cache_all
-#if defined(CONFIG_CACHE_FEROCEON_L2) && !defined(CONFIG_L2_CACHE_WRITETHROUGH)
+#if defined(CONFIG_CACHE_FEROCEON_L2) && \
+ !defined(CONFIG_CACHE_FEROCEON_L2_WRITETHROUGH)
mov r0, #0
mcr p15, 1, r0, c15, c9, 0 @ clean L2
mcr p15, 0, r0, c7, c10, 4 @ drain WB
@@ -389,7 +390,8 @@
.align 5
ENTRY(cpu_feroceon_dcache_clean_area)
-#if defined(CONFIG_CACHE_FEROCEON_L2) && !defined(CONFIG_L2_CACHE_WRITETHROUGH)
+#if defined(CONFIG_CACHE_FEROCEON_L2) && \
+ !defined(CONFIG_CACHE_FEROCEON_L2_WRITETHROUGH)
mov r2, r0
mov r3, r1
#endif
@@ -397,7 +399,8 @@
add r0, r0, #CACHE_DLINESIZE
subs r1, r1, #CACHE_DLINESIZE
bhi 1b
-#if defined(CONFIG_CACHE_FEROCEON_L2) && !defined(CONFIG_L2_CACHE_WRITETHROUGH)
+#if defined(CONFIG_CACHE_FEROCEON_L2) && \
+ !defined(CONFIG_CACHE_FEROCEON_L2_WRITETHROUGH)
1: mcr p15, 1, r2, c15, c9, 1 @ clean L2 entry
add r2, r2, #CACHE_DLINESIZE
subs r3, r3, #CACHE_DLINESIZE
@@ -466,7 +469,8 @@
str r2, [r0] @ hardware version
mov r0, r0
mcr p15, 0, r0, c7, c10, 1 @ clean D entry
-#if defined(CONFIG_CACHE_FEROCEON_L2) && !defined(CONFIG_L2_CACHE_WRITETHROUGH)
+#if defined(CONFIG_CACHE_FEROCEON_L2) && \
+ !defined(CONFIG_CACHE_FEROCEON_L2_WRITETHROUGH)
mcr p15, 1, r0, c15, c9, 1 @ clean L2 entry
#endif
mcr p15, 0, r0, c7, c10, 4 @ drain WB