omap: mux: Replace omap_cfg_reg() with new style signal or gpio functions
Replace omap_cfg_reg() with new style signal or gpio functions
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/board-omap3evm.c b/arch/arm/mach-omap2/board-omap3evm.c
index ad174ae..0457f61 100644
--- a/arch/arm/mach-omap2/board-omap3evm.c
+++ b/arch/arm/mach-omap2/board-omap3evm.c
@@ -224,7 +224,7 @@
unsigned gpio, unsigned ngpio)
{
/* gpio + 0 is "mmc0_cd" (input/IRQ) */
- omap_cfg_reg(L8_34XX_GPIO63);
+ omap_mux_init_gpio(63, OMAP_PIN_INPUT);
mmc[0].gpio_cd = gpio + 0;
twl4030_mmc_init(mmc);
@@ -450,24 +450,24 @@
#endif
if (get_omap3_evm_rev() >= OMAP3EVM_BOARD_GEN_2) {
/* enable EHCI VBUS using GPIO22 */
- omap_cfg_reg(AF9_34XX_GPIO22);
+ omap_mux_init_gpio(22, OMAP_PIN_INPUT_PULLUP);
gpio_request(OMAP3_EVM_EHCI_VBUS, "enable EHCI VBUS");
gpio_direction_output(OMAP3_EVM_EHCI_VBUS, 0);
gpio_set_value(OMAP3_EVM_EHCI_VBUS, 1);
/* Select EHCI port on main board */
- omap_cfg_reg(U3_34XX_GPIO61);
+ omap_mux_init_gpio(61, OMAP_PIN_INPUT_PULLUP);
gpio_request(OMAP3_EVM_EHCI_SELECT, "select EHCI port");
gpio_direction_output(OMAP3_EVM_EHCI_SELECT, 0);
gpio_set_value(OMAP3_EVM_EHCI_SELECT, 0);
/* setup EHCI phy reset config */
- omap_cfg_reg(AH14_34XX_GPIO21);
+ omap_mux_init_gpio(21, OMAP_PIN_INPUT_PULLUP);
ehci_pdata.reset_gpio_port[1] = 21;
} else {
/* setup EHCI phy reset on MDC */
- omap_cfg_reg(AF4_34XX_GPIO135_OUT);
+ omap_mux_init_gpio(135, OMAP_PIN_OUTPUT);
ehci_pdata.reset_gpio_port[1] = 135;
}
usb_musb_init();