| /* hplance.c  : the  Linux/hp300/lance ethernet driver | 
 |  * | 
 |  * Copyright (C) 05/1998 Peter Maydell <pmaydell@chiark.greenend.org.uk> | 
 |  * Based on the Sun Lance driver and the NetBSD HP Lance driver | 
 |  * Uses the generic 7990.c LANCE code. | 
 |  */ | 
 |  | 
 | #include <linux/module.h> | 
 | #include <linux/kernel.h> | 
 | #include <linux/types.h> | 
 | #include <linux/interrupt.h> | 
 | #include <linux/ioport.h> | 
 | #include <linux/slab.h> | 
 | #include <linux/string.h> | 
 | #include <linux/delay.h> | 
 | #include <linux/init.h> | 
 | #include <linux/errno.h> | 
 | /* Used for the temporal inet entries and routing */ | 
 | #include <linux/socket.h> | 
 | #include <linux/route.h> | 
 | #include <linux/dio.h> | 
 | #include <linux/netdevice.h> | 
 | #include <linux/etherdevice.h> | 
 | #include <linux/skbuff.h> | 
 |  | 
 | #include <asm/system.h> | 
 | #include <asm/io.h> | 
 | #include <asm/pgtable.h> | 
 |  | 
 | #include "hplance.h" | 
 |  | 
 | /* We have 16834 bytes of RAM for the init block and buffers. This places | 
 |  * an upper limit on the number of buffers we can use. NetBSD uses 8 Rx | 
 |  * buffers and 2 Tx buffers. | 
 |  */ | 
 | #define LANCE_LOG_TX_BUFFERS 1 | 
 | #define LANCE_LOG_RX_BUFFERS 3 | 
 |  | 
 | #include "7990.h"                                 /* use generic LANCE code */ | 
 |  | 
 | /* Our private data structure */ | 
 | struct hplance_private { | 
 | 	struct lance_private lance; | 
 | }; | 
 |  | 
 | /* function prototypes... This is easy because all the grot is in the | 
 |  * generic LANCE support. All we have to support is probing for boards, | 
 |  * plus board-specific init, open and close actions.  | 
 |  * Oh, and we need to tell the generic code how to read and write LANCE registers... | 
 |  */ | 
 | static int __devinit hplance_init_one(struct dio_dev *d, | 
 | 				const struct dio_device_id *ent); | 
 | static void __devinit hplance_init(struct net_device *dev,  | 
 | 				struct dio_dev *d); | 
 | static void __devexit hplance_remove_one(struct dio_dev *d); | 
 | static void hplance_writerap(void *priv, unsigned short value); | 
 | static void hplance_writerdp(void *priv, unsigned short value); | 
 | static unsigned short hplance_readrdp(void *priv); | 
 | static int hplance_open(struct net_device *dev); | 
 | static int hplance_close(struct net_device *dev); | 
 |  | 
 | static struct dio_device_id hplance_dio_tbl[] = { | 
 | 	{ DIO_ID_LAN }, | 
 | 	{ 0 } | 
 | }; | 
 |  | 
 | static struct dio_driver hplance_driver = { | 
 | 	.name      = "hplance", | 
 | 	.id_table  = hplance_dio_tbl, | 
 | 	.probe     = hplance_init_one, | 
 | 	.remove    = __devexit_p(hplance_remove_one), | 
 | }; | 
 |  | 
 | /* Find all the HP Lance boards and initialise them... */ | 
 | static int __devinit hplance_init_one(struct dio_dev *d, | 
 | 				const struct dio_device_id *ent) | 
 | { | 
 | 	struct net_device *dev; | 
 | 	int err = -ENOMEM; | 
 |  | 
 | 	dev = alloc_etherdev(sizeof(struct hplance_private)); | 
 | 	if (!dev) | 
 | 		goto out; | 
 |  | 
 | 	err = -EBUSY; | 
 | 	if (!request_mem_region(dio_resource_start(d), | 
 | 				dio_resource_len(d), d->name)) | 
 | 		goto out_free_netdev; | 
 |  | 
 | 	hplance_init(dev, d); | 
 | 	err = register_netdev(dev); | 
 | 	if (err) | 
 | 		goto out_release_mem_region; | 
 |  | 
 | 	dio_set_drvdata(d, dev); | 
 | 	return 0; | 
 |  | 
 |  out_release_mem_region: | 
 | 	release_mem_region(dio_resource_start(d), dio_resource_len(d)); | 
 |  out_free_netdev: | 
 | 	free_netdev(dev); | 
 |  out: | 
 | 	return err; | 
 | } | 
 |  | 
 | static void __devexit hplance_remove_one(struct dio_dev *d) | 
 | { | 
 | 	struct net_device *dev = dio_get_drvdata(d); | 
 |  | 
 | 	unregister_netdev(dev); | 
 | 	release_mem_region(dio_resource_start(d), dio_resource_len(d)); | 
 | 	free_netdev(dev); | 
 | } | 
 |  | 
 | /* Initialise a single lance board at the given DIO device */ | 
 | static void __init hplance_init(struct net_device *dev, struct dio_dev *d) | 
 | { | 
 |         unsigned long va = (d->resource.start + DIO_VIRADDRBASE); | 
 |         struct hplance_private *lp; | 
 |         int i; | 
 |          | 
 |         printk(KERN_INFO "%s: %s; select code %d, addr", dev->name, d->name, d->scode); | 
 |  | 
 |         /* reset the board */ | 
 |         out_8(va+DIO_IDOFF, 0xff); | 
 |         udelay(100);                              /* ariba! ariba! udelay! udelay! */ | 
 |  | 
 |         /* Fill the dev fields */ | 
 |         dev->base_addr = va; | 
 |         dev->open = &hplance_open; | 
 |         dev->stop = &hplance_close; | 
 | #ifdef CONFIG_NET_POLL_CONTROLLER | 
 |         dev->poll_controller = lance_poll; | 
 | #endif | 
 |         dev->hard_start_xmit = &lance_start_xmit; | 
 |         dev->get_stats = &lance_get_stats; | 
 |         dev->set_multicast_list = &lance_set_multicast; | 
 |         dev->dma = 0; | 
 |          | 
 |         for (i=0; i<6; i++) { | 
 |                 /* The NVRAM holds our ethernet address, one nibble per byte, | 
 |                  * at bytes NVRAMOFF+1,3,5,7,9... | 
 |                  */ | 
 |                 dev->dev_addr[i] = ((in_8(va + HPLANCE_NVRAMOFF + i*4 + 1) & 0xF) << 4) | 
 |                         | (in_8(va + HPLANCE_NVRAMOFF + i*4 + 3) & 0xF); | 
 |                 printk("%c%2.2x", i == 0 ? ' ' : ':', dev->dev_addr[i]); | 
 |         } | 
 |          | 
 |         lp = netdev_priv(dev); | 
 |         lp->lance.name = (char*)d->name;                /* discards const, shut up gcc */ | 
 |         lp->lance.base = va; | 
 |         lp->lance.init_block = (struct lance_init_block *)(va + HPLANCE_MEMOFF); /* CPU addr */ | 
 |         lp->lance.lance_init_block = 0;                 /* LANCE addr of same RAM */ | 
 |         lp->lance.busmaster_regval = LE_C3_BSWP;        /* we're bigendian */ | 
 |         lp->lance.irq = d->ipl; | 
 |         lp->lance.writerap = hplance_writerap; | 
 |         lp->lance.writerdp = hplance_writerdp; | 
 |         lp->lance.readrdp = hplance_readrdp; | 
 |         lp->lance.lance_log_rx_bufs = LANCE_LOG_RX_BUFFERS; | 
 |         lp->lance.lance_log_tx_bufs = LANCE_LOG_TX_BUFFERS; | 
 |         lp->lance.rx_ring_mod_mask = RX_RING_MOD_MASK; | 
 |         lp->lance.tx_ring_mod_mask = TX_RING_MOD_MASK; | 
 | 	printk(", irq %d\n", lp->lance.irq); | 
 | } | 
 |  | 
 | /* This is disgusting. We have to check the DIO status register for ack every | 
 |  * time we read or write the LANCE registers. | 
 |  */ | 
 | static void hplance_writerap(void *priv, unsigned short value) | 
 | { | 
 | 	struct lance_private *lp = (struct lance_private *)priv; | 
 | 	do { | 
 | 		out_be16(lp->base + HPLANCE_REGOFF + LANCE_RAP, value); | 
 | 	} while ((in_8(lp->base + HPLANCE_STATUS) & LE_ACK) == 0); | 
 | } | 
 |  | 
 | static void hplance_writerdp(void *priv, unsigned short value) | 
 | { | 
 | 	struct lance_private *lp = (struct lance_private *)priv; | 
 | 	do { | 
 | 		out_be16(lp->base + HPLANCE_REGOFF + LANCE_RDP, value); | 
 | 	} while ((in_8(lp->base + HPLANCE_STATUS) & LE_ACK) == 0); | 
 | } | 
 |  | 
 | static unsigned short hplance_readrdp(void *priv) | 
 | { | 
 | 	struct lance_private *lp = (struct lance_private *)priv; | 
 | 	__u16 value; | 
 | 	do { | 
 | 		value = in_be16(lp->base + HPLANCE_REGOFF + LANCE_RDP); | 
 | 	} while ((in_8(lp->base + HPLANCE_STATUS) & LE_ACK) == 0); | 
 | 	return value; | 
 | } | 
 |  | 
 | static int hplance_open(struct net_device *dev) | 
 | { | 
 |         int status; | 
 |         struct lance_private *lp = netdev_priv(dev); | 
 |          | 
 |         status = lance_open(dev);                 /* call generic lance open code */ | 
 |         if (status) | 
 |                 return status; | 
 |         /* enable interrupts at board level. */ | 
 |         out_8(lp->base + HPLANCE_STATUS, LE_IE); | 
 |  | 
 |         return 0; | 
 | } | 
 |  | 
 | static int hplance_close(struct net_device *dev) | 
 | { | 
 |         struct lance_private *lp = netdev_priv(dev); | 
 |  | 
 |         out_8(lp->base + HPLANCE_STATUS, 0);	/* disable interrupts at boardlevel */ | 
 |         lance_close(dev); | 
 |         return 0; | 
 | } | 
 |  | 
 | int __init hplance_init_module(void) | 
 | { | 
 | 	return dio_module_init(&hplance_driver); | 
 | } | 
 |  | 
 | void __exit hplance_cleanup_module(void) | 
 | { | 
 |         dio_unregister_driver(&hplance_driver); | 
 | } | 
 |  | 
 | module_init(hplance_init_module); | 
 | module_exit(hplance_cleanup_module); | 
 |  | 
 | MODULE_LICENSE("GPL"); |