mac80211: synchronize scan off/on-channel and PS states
commit aacde9ee45225f7e0b90960f479aef83c66bfdc0 upstream.
Since:
commit b23b025fe246f3acc2988eb6d400df34c27cb8ae
Author: Ben Greear <greearb@candelatech.com>
Date: Fri Feb 4 11:54:17 2011 -0800
mac80211: Optimize scans on current operating channel.
we do not disable PS while going back to operational channel (on
ieee80211_scan_state_suspend) and deffer that until scan finish.
But since we are allowed to send frames, we can send a frame to AP
without PM bit set, so disable PS on AP side. Then when we switch
to off-channel (in ieee80211_scan_state_resume) we do not enable PS.
Hence we are off-channel with PS disabled, frames are not buffered
by AP.
To fix remove offchannel_ps_disable argument and always enable PS when
going off-channel and disable it when going on-channel, like it was
before.
Cc: stable@vger.kernel.org # 2.6.39+
Signed-off-by: Stanislaw Gruszka <sgruszka@redhat.com>
Tested-by: Seth Forshee <seth.forshee@canonical.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/net/mac80211/scan.c b/net/mac80211/scan.c
index e95d494..bcc57f9 100644
--- a/net/mac80211/scan.c
+++ b/net/mac80211/scan.c
@@ -329,7 +329,7 @@
if (!was_hw_scan) {
ieee80211_configure_filter(local);
drv_sw_scan_complete(local);
- ieee80211_offchannel_return(local, true);
+ ieee80211_offchannel_return(local);
}
ieee80211_recalc_idle(local);
@@ -374,7 +374,7 @@
local->next_scan_state = SCAN_DECISION;
local->scan_channel_idx = 0;
- ieee80211_offchannel_stop_vifs(local, true);
+ ieee80211_offchannel_stop_vifs(local);
ieee80211_configure_filter(local);
@@ -629,12 +629,8 @@
local->scan_channel = NULL;
ieee80211_hw_config(local, IEEE80211_CONF_CHANGE_CHANNEL);
- /*
- * Re-enable vifs and beaconing. Leave PS
- * in off-channel state..will put that back
- * on-channel at the end of scanning.
- */
- ieee80211_offchannel_return(local, false);
+ /* disable PS */
+ ieee80211_offchannel_return(local);
*next_delay = HZ / 5;
/* afterwards, resume scan & go to next channel */
@@ -644,8 +640,7 @@
static void ieee80211_scan_state_resume(struct ieee80211_local *local,
unsigned long *next_delay)
{
- /* PS already is in off-channel mode */
- ieee80211_offchannel_stop_vifs(local, false);
+ ieee80211_offchannel_stop_vifs(local);
if (local->ops->flush) {
drv_flush(local, false);