cpufreq for freescale mx51
Currently, only two operating points: 160Mhz and 800Mhz.
the operating points are tested on babbage 3.0
Signed-off-by: Yong Shen <yong.shen@linaro.org>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/mach-mx5/board-mx51_babbage.c b/arch/arm/mach-mx5/board-mx51_babbage.c
index 39304b4..cbf07ff 100644
--- a/arch/arm/mach-mx5/board-mx51_babbage.c
+++ b/arch/arm/mach-mx5/board-mx51_babbage.c
@@ -1,5 +1,5 @@
/*
- * Copyright 2009 Freescale Semiconductor, Inc. All Rights Reserved.
+ * Copyright 2009-2010 Freescale Semiconductor, Inc. All Rights Reserved.
* Copyright (C) 2009-2010 Amit Kucheria <amit.kucheria@canonical.com>
*
* The code contained herein is licensed under the GNU General Public
@@ -32,6 +32,7 @@
#include "devices-imx51.h"
#include "devices.h"
+#include "cpu_op-mx51.h"
#define BABBAGE_USB_HUB_RESET (0*32 + 7) /* GPIO_1_7 */
#define BABBAGE_USBH1_STP (0*32 + 27) /* GPIO_1_27 */
@@ -298,6 +299,9 @@
{
struct pad_desc usbh1stp = MX51_PAD_USBH1_STP__USBH1_STP;
+#if defined(CONFIG_CPU_FREQ_IMX)
+ get_cpu_op = mx51_get_cpu_op;
+#endif
mxc_iomux_v3_setup_multiple_pads(mx51babbage_pads,
ARRAY_SIZE(mx51babbage_pads));
mxc_init_imx_uart();