Blackfin arch: Clean up trace buffer handling, No major functional changes.
Turns on trace earlier, so crashes at kernel start should print out a
trace, making things easier to debug.
Signed-off-by: Robin Getz <robin.getz@analog.com>
Signed-off-by: Mike Frysinger <michael.frysinger@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
diff --git a/arch/blackfin/kernel/setup.c b/arch/blackfin/kernel/setup.c
index 07c1cfd..a86bf65 100644
--- a/arch/blackfin/kernel/setup.c
+++ b/arch/blackfin/kernel/setup.c
@@ -194,6 +194,17 @@
/* this give a chance to get printk() working before crash. */
#endif
+ printk(KERN_INFO "Hardware Trace ");
+ if (bfin_read_TBUFCTL() & 0x1 )
+ printk("Active ");
+ else
+ printk("Off ");
+ if (bfin_read_TBUFCTL() & 0x2)
+ printk("and Enabled\n");
+ else
+ printk("and Disabled\n");
+
+
#if defined(CONFIG_CHR_DEV_FLASH) || defined(CONFIG_BLK_DEV_FLASH)
/* we need to initialize the Flashrom device here since we might
* do things with flash early on in the boot
@@ -397,9 +408,6 @@
_bfin_swrst = bfin_read_SWRST();
#endif
- printk(KERN_INFO "Hardware Trace Enabled\n");
- bfin_write_TBUFCTL(0x03);
-
/* Copy atomic sequences to their fixed location, and sanity check that
these locations are the ones that we advertise to userspace. */
memcpy((void *)FIXED_CODE_START, &fixed_code_start,