[media] drxk: Allow setting it on dynamic_clock mode
This is used on az6007.
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/dvb/frontends/drxk.h b/drivers/media/dvb/frontends/drxk.h
index 0209818..6b0fd2c 100644
--- a/drivers/media/dvb/frontends/drxk.h
+++ b/drivers/media/dvb/frontends/drxk.h
@@ -7,15 +7,17 @@
/**
* struct drxk_config - Configure the initial parameters for DRX-K
*
- * adr: I2C Address of the DRX-K
- * parallel_ts: true means that the device uses parallel TS,
+ * @adr: I2C Address of the DRX-K
+ * @parallel_ts: True means that the device uses parallel TS,
* Serial otherwise.
- * single_master: Device is on the single master mode
- * no_i2c_bridge: Don't switch the I2C bridge to talk with tuner
- * antenna_gpio: GPIO bit used to control the antenna
- * antenna_dvbt: GPIO bit for changing antenna to DVB-C. A value of 1
+ * @dynamic_clk: True means that the clock will be dynamically
+ * adjusted. Static clock otherwise.
+ * @single_master: Device is on the single master mode
+ * @no_i2c_bridge: Don't switch the I2C bridge to talk with tuner
+ * @antenna_gpio: GPIO bit used to control the antenna
+ * @antenna_dvbt: GPIO bit for changing antenna to DVB-C. A value of 1
* means that 1=DVBC, 0 = DVBT. Zero means the opposite.
- * microcode_name: Name of the firmware file with the microcode
+ * @microcode_name: Name of the firmware file with the microcode
*
* On the *_gpio vars, bit 0 is UIO-1, bit 1 is UIO-2 and bit 2 is
* UIO-3.
@@ -25,6 +27,7 @@
bool single_master;
bool no_i2c_bridge;
bool parallel_ts;
+ bool dynamic_clk;
bool antenna_dvbt;
u16 antenna_gpio;