OMAP3: GPIO: Only enable WAKEUPEN for edge detection GPIOs
According to the GPIO 'Wakeup and Interrupt' section of the TRM[1],
wake-up requests can only be generated on edge transitions.
Also for OMAP3, only edge GPIOs may lose interrupts when PER enters
RET/OFF state, this is addressed by gpio prepare|resume idle functions
[1] Section 25.5.3.1 OMAP34xx_ES3.1_TRM_V_Q
Signed-off-by: Chunqiu Wang <cqwang@motorola.com>
Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>
diff --git a/arch/arm/plat-omap/gpio.c b/arch/arm/plat-omap/gpio.c
index 6216f4f..2f185ff 100644
--- a/arch/arm/plat-omap/gpio.c
+++ b/arch/arm/plat-omap/gpio.c
@@ -724,7 +724,11 @@
OMAP4_GPIO_IRQWAKEN0);
}
} else {
- if (trigger != 0)
+ /*
+ * GPIO wakeup request can only be generated on edge
+ * transitions
+ */
+ if (trigger & IRQ_TYPE_EDGE_BOTH)
__raw_writel(1 << gpio, bank->base
+ OMAP24XX_GPIO_SETWKUENA);
else
@@ -734,7 +738,13 @@
}
/* This part needs to be executed always for OMAP34xx */
if (cpu_is_omap34xx() || (bank->non_wakeup_gpios & gpio_bit)) {
- if (trigger != 0)
+ /*
+ * Log the edge gpio and manually trigger the IRQ
+ * after resume if the input level changes
+ * to avoid irq lost during PER RET/OFF mode
+ * Applies for omap2 non-wakeup gpio and all omap3 gpios
+ */
+ if (trigger & IRQ_TYPE_EDGE_BOTH)
bank->enabled_non_wakeup_gpios |= gpio_bit;
else
bank->enabled_non_wakeup_gpios &= ~gpio_bit;