USB: musb: allow the Blackfin vrsel gpio to be active low
Rather than hardcoding the gpio levels for vrsel, allow the platform
resources to handle this so boards can be active high or low.
Signed-off-by: Cliff Cai <cliff.cai@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Felipe Balbi <felipe.balbi@nokia.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/musb/blackfin.c b/drivers/usb/musb/blackfin.c
index 7c71eb4..eb4392f 100644
--- a/drivers/usb/musb/blackfin.c
+++ b/drivers/usb/musb/blackfin.c
@@ -238,10 +238,10 @@
static void bfin_set_vbus(struct musb *musb, int is_on)
{
- if (is_on)
- gpio_set_value(musb->config->gpio_vrsel, 1);
- else
- gpio_set_value(musb->config->gpio_vrsel, 0);
+ int value = musb->config->gpio_vrsel_active;
+ if (!is_on)
+ value = !value;
+ gpio_set_value(musb->config->gpio_vrsel, value);
DBG(1, "VBUS %s, devctl %02x "
/* otg %3x conf %08x prcm %08x */ "\n",
diff --git a/include/linux/usb/musb.h b/include/linux/usb/musb.h
index f3d68f6..fbb83fe 100644
--- a/include/linux/usb/musb.h
+++ b/include/linux/usb/musb.h
@@ -88,6 +88,7 @@
#ifdef CONFIG_BLACKFIN
/* A GPIO controlling VRSEL in Blackfin */
unsigned int gpio_vrsel;
+ unsigned int gpio_vrsel_active;
#endif
};