| /* |
| * Copyright (C) 2007 Atmel Corporation |
| * |
| * Driver for the AT32AP700X PS/2 controller (PSIF). |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of the GNU General Public License version 2 as published |
| * by the Free Software Foundation. |
| */ |
| |
| #ifndef __INCLUDE_ATMEL_PWM_BL_H |
| #define __INCLUDE_ATMEL_PWM_BL_H |
| |
| /** |
| * struct atmel_pwm_bl_platform_data |
| * @pwm_channel: which PWM channel in the PWM module to use. |
| * @pwm_frequency: PWM frequency to generate, the driver will try to be as |
| * close as the prescaler allows. |
| * @pwm_compare_max: value to use in the PWM channel compare register. |
| * @pwm_duty_max: maximum duty cycle value, must be less than or equal to |
| * pwm_compare_max. |
| * @pwm_duty_min: minimum duty cycle value, must be less than pwm_duty_max. |
| * @pwm_active_low: set to one if the low part of the PWM signal increases the |
| * brightness of the backlight. |
| * @gpio_on: GPIO line to control the backlight on/off, set to -1 if not used. |
| * @on_active_low: set to one if the on/off signal is on when GPIO is low. |
| * |
| * This struct must be added to the platform device in the board code. It is |
| * used by the atmel-pwm-bl driver to setup the GPIO to control on/off and the |
| * PWM device. |
| */ |
| struct atmel_pwm_bl_platform_data { |
| unsigned int pwm_channel; |
| unsigned int pwm_frequency; |
| unsigned int pwm_compare_max; |
| unsigned int pwm_duty_max; |
| unsigned int pwm_duty_min; |
| unsigned int pwm_active_low; |
| int gpio_on; |
| unsigned int on_active_low; |
| }; |
| |
| #endif /* __INCLUDE_ATMEL_PWM_BL_H */ |