| To configure the Crystal CS423x sound chip and activate its DSP functions, |
| modules may be loaded in this order: |
| |
| modprobe sound |
| insmod ad1848 |
| insmod uart401 |
| insmod cs4232 io=* irq=* dma=* dma2=* |
| |
| This is the meaning of the parameters: |
| |
| io--I/O address of the Windows Sound System (normally 0x534) |
| irq--IRQ of this device |
| dma and dma2--DMA channels (DMA2 may be 0) |
| |
| On some cards, the board attempts to do non-PnP setup, and fails. If you |
| have problems, use Linux' PnP facilities. |
| |
| To get MIDI facilities add |
| |
| insmod opl3 io=* |
| |
| where "io" is the I/O address of the OPL3 synthesizer. This will be shown |
| in /proc/sys/pnp and is normally 0x388. |