spi: move common spi_setup() functionality into core
Start moving some spi_setup() functionality into the SPI core from the
various spi_master controller drivers:
- Make that function stop being an inline;
- Move two common idioms from drivers into that new function:
* Default bits_per_word to 8 if that field isn't set
* Issue a standardized dev_dbg() message
This is a net minor source code shrink, and supports enhancments found in
some follow-up patches.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/spi/spi_bitbang.c b/drivers/spi/spi_bitbang.c
index 85e61f4..855b0b0 100644
--- a/drivers/spi/spi_bitbang.c
+++ b/drivers/spi/spi_bitbang.c
@@ -201,9 +201,6 @@
spi->controller_state = cs;
}
- if (!spi->bits_per_word)
- spi->bits_per_word = 8;
-
/* per-word shift register access, in hardware or bitbanging */
cs->txrx_word = bitbang->txrx_word[spi->mode & (SPI_CPOL|SPI_CPHA)];
if (!cs->txrx_word)
@@ -213,9 +210,7 @@
if (retval < 0)
return retval;
- dev_dbg(&spi->dev, "%s, mode %d, %u bits/w, %u nsec/bit\n",
- __func__, spi->mode & (SPI_CPOL | SPI_CPHA),
- spi->bits_per_word, 2 * cs->nsecs);
+ dev_dbg(&spi->dev, "%s, %u nsec/bit\n", __func__, 2 * cs->nsecs);
/* NOTE we _need_ to call chipselect() early, ideally with adapter
* setup, unless the hardware defaults cooperate to avoid confusion