net: make vlan ndo_vlan_rx_[add/kill]_vid return error value
Let caller know the result of adding/removing vlan id to/from vlan
filter.
In some drivers I make those functions to just return 0. But in those
where there is able to see if hw setup went correctly, return value is
set appropriately.
Signed-off-by: Jiri Pirko <jpirko@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/adaptec/starfire.c b/drivers/net/ethernet/adaptec/starfire.c
index a446e25..cb4f38a 100644
--- a/drivers/net/ethernet/adaptec/starfire.c
+++ b/drivers/net/ethernet/adaptec/starfire.c
@@ -607,7 +607,7 @@
#ifdef VLAN_SUPPORT
-static void netdev_vlan_rx_add_vid(struct net_device *dev, unsigned short vid)
+static int netdev_vlan_rx_add_vid(struct net_device *dev, unsigned short vid)
{
struct netdev_private *np = netdev_priv(dev);
@@ -617,9 +617,11 @@
set_bit(vid, np->active_vlans);
set_rx_mode(dev);
spin_unlock(&np->lock);
+
+ return 0;
}
-static void netdev_vlan_rx_kill_vid(struct net_device *dev, unsigned short vid)
+static int netdev_vlan_rx_kill_vid(struct net_device *dev, unsigned short vid)
{
struct netdev_private *np = netdev_priv(dev);
@@ -629,6 +631,8 @@
clear_bit(vid, np->active_vlans);
set_rx_mode(dev);
spin_unlock(&np->lock);
+
+ return 0;
}
#endif /* VLAN_SUPPORT */