mac80211: add ieee80211_sdata_running
Instead of always using netif_running(sdata->dev)
use ieee80211_sdata_running(sdata) now which is
just an inline containing netif_running() for now.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/mac80211/iface.c b/net/mac80211/iface.c
index a6e6da3..1ceca14 100644
--- a/net/mac80211/iface.c
+++ b/net/mac80211/iface.c
@@ -65,7 +65,7 @@
struct ieee80211_sub_if_data *sdata = IEEE80211_DEV_TO_SUB_IF(dev);
int ret;
- if (netif_running(dev))
+ if (ieee80211_sdata_running(sdata))
return -EBUSY;
ret = eth_mac_addr(dev, addr);
@@ -111,7 +111,7 @@
list_for_each_entry(nsdata, &local->interfaces, list) {
struct net_device *ndev = nsdata->dev;
- if (ndev != dev && netif_running(ndev)) {
+ if (ndev != dev && ieee80211_sdata_running(nsdata)) {
/*
* Allow only a single IBSS interface to be up at any
* time. This is restricted because beacon distribution
@@ -197,7 +197,7 @@
struct net_device *ndev = nsdata->dev;
/*
- * No need to check netif_running since we do not allow
+ * No need to check running since we do not allow
* it to start up with this invalid address.
*/
if (compare_ether_addr(null_addr, ndev->dev_addr) == 0) {
@@ -756,7 +756,7 @@
* and goes into the requested mode.
*/
- if (netif_running(sdata->dev))
+ if (ieee80211_sdata_running(sdata))
return -EBUSY;
/* Purge and reset type-dependent state. */
@@ -930,7 +930,7 @@
return ieee80211_idle_off(local, "scanning");
list_for_each_entry(sdata, &local->interfaces, list) {
- if (!netif_running(sdata->dev))
+ if (!ieee80211_sdata_running(sdata))
continue;
/* do not count disabled managed interfaces */
if (sdata->vif.type == NL80211_IFTYPE_STATION &&