starfire: Move the Adaptec driver
Move the Adaptec driver into drivers/net/ethernet/adaptec/ and make
the necessary Kconfig and Makefile changes.
CC: Ion Badulescu <ionut@badula.org>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/adaptec/Kconfig b/drivers/net/ethernet/adaptec/Kconfig
new file mode 100644
index 0000000..5e9dbe9
--- /dev/null
+++ b/drivers/net/ethernet/adaptec/Kconfig
@@ -0,0 +1,34 @@
+#
+# Adaptec network device configuration
+#
+
+config NET_VENDOR_ADAPTEC
+ bool "Adaptec devices"
+ depends on PCI
+ ---help---
+ If you have a network (Ethernet) card belonging to this class, say Y
+ and read the Ethernet-HOWTO, available from
+ <http://www.tldp.org/docs.html#howto>.
+
+ Note that the answer to this question doesn't directly affect the
+ kernel: saying N will just cause the configurator to skip all
+ the questions about Adaptec cards. If you say Y, you will be asked for
+ your specific card in the following questions.
+
+if NET_VENDOR_ADAPTEC
+
+config ADAPTEC_STARFIRE
+ tristate "Adaptec Starfire/DuraLAN support"
+ depends on PCI
+ select CRC32
+ select MII
+ ---help---
+ Say Y here if you have an Adaptec Starfire (or DuraLAN) PCI network
+ adapter. The DuraLAN chip is used on the 64 bit PCI boards from
+ Adaptec e.g. the ANA-6922A. The older 32 bit boards use the tulip
+ driver.
+
+ To compile this driver as a module, choose M here: the module
+ will be called starfire. This is recommended.
+
+endif # NET_VENDOR_ADAPTEC