sh: Mass ctrl_in/outX to __raw_read/writeX conversion.
The old ctrl in/out routines are non-portable and unsuitable for
cross-platform use. While drivers/sh has already been sanitized, there
is still quite a lot of code that is not. This converts the arch/sh/ bits
over, which permits us to flag the routines as deprecated whilst still
building with -Werror for the architecture code, and to ensure that
future users are not added.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/arch/sh/boards/mach-kfr2r09/setup.c b/arch/sh/boards/mach-kfr2r09/setup.c
index 5d7b5d9..ca9e82d 100644
--- a/arch/sh/boards/mach-kfr2r09/setup.c
+++ b/arch/sh/boards/mach-kfr2r09/setup.c
@@ -282,7 +282,7 @@
* use 1.8 V for VccQ_VIO
* use 2.85V for VccQ_SR
*/
- ctrl_outw((ctrl_inw(DRVCRB) & ~0x0003) | 0x0001, DRVCRB);
+ __raw_writew((__raw_readw(DRVCRB) & ~0x0003) | 0x0001, DRVCRB);
/* reset clear */
ret = gpio_request(GPIO_PTB4, NULL);
@@ -492,13 +492,13 @@
if (kfr2r09_usb0_gadget_i2c_setup() != 0)
return -ENODEV; /* unable to configure using i2c */
- ctrl_outw((ctrl_inw(PORT_MSELCRB) & ~0xc000) | 0x8000, PORT_MSELCRB);
+ __raw_writew((__raw_readw(PORT_MSELCRB) & ~0xc000) | 0x8000, PORT_MSELCRB);
gpio_request(GPIO_FN_PDSTATUS, NULL); /* R-standby disables USB clock */
gpio_request(GPIO_PTV6, NULL); /* USBCLK_ON */
gpio_direction_output(GPIO_PTV6, 1); /* USBCLK_ON = H */
msleep(20); /* wait 20ms to let the clock settle */
clk_enable(clk_get(NULL, "usb0"));
- ctrl_outw(0x0600, 0xa40501d4);
+ __raw_writew(0x0600, 0xa40501d4);
return 0;
}
@@ -526,12 +526,12 @@
gpio_direction_output(GPIO_PTG3, 1); /* HPON_ON = H */
/* setup NOR flash at CS0 */
- ctrl_outl(0x36db0400, BSC_CS0BCR);
- ctrl_outl(0x00000500, BSC_CS0WCR);
+ __raw_writel(0x36db0400, BSC_CS0BCR);
+ __raw_writel(0x00000500, BSC_CS0WCR);
/* setup NAND flash at CS4 */
- ctrl_outl(0x36db0400, BSC_CS4BCR);
- ctrl_outl(0x00000500, BSC_CS4WCR);
+ __raw_writel(0x36db0400, BSC_CS4BCR);
+ __raw_writel(0x00000500, BSC_CS4WCR);
/* setup KEYSC pins */
gpio_request(GPIO_FN_KEYOUT0, NULL);