sh: Mass ctrl_in/outX to __raw_read/writeX conversion.
The old ctrl in/out routines are non-portable and unsuitable for
cross-platform use. While drivers/sh has already been sanitized, there
is still quite a lot of code that is not. This converts the arch/sh/ bits
over, which permits us to flag the routines as deprecated whilst still
building with -Werror for the architecture code, and to ensure that
future users are not added.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/arch/sh/drivers/pci/fixups-rts7751r2d.c b/arch/sh/drivers/pci/fixups-rts7751r2d.c
index 7898f14..e248516 100644
--- a/arch/sh/drivers/pci/fixups-rts7751r2d.c
+++ b/arch/sh/drivers/pci/fixups-rts7751r2d.c
@@ -43,7 +43,7 @@
{
unsigned long bcr1, mcr;
- bcr1 = ctrl_inl(SH7751_BCR1);
+ bcr1 = __raw_readl(SH7751_BCR1);
bcr1 |= 0x40080000; /* Enable Bit 19 BREQEN, set PCIC to slave */
pci_write_reg(chan, bcr1, SH4_PCIBCR1);
@@ -54,7 +54,7 @@
pci_write_reg(chan, 0xfb900047, SH7751_PCICONF1);
pci_write_reg(chan, 0xab000001, SH7751_PCICONF4);
- mcr = ctrl_inl(SH7751_MCR);
+ mcr = __raw_readl(SH7751_MCR);
mcr = (mcr & PCIMCR_MRSET_OFF) & PCIMCR_RFSH_OFF;
pci_write_reg(chan, mcr, SH4_PCIMCR);
diff --git a/arch/sh/drivers/pci/pci-sh4.h b/arch/sh/drivers/pci/pci-sh4.h
index 3d5296c..4744a7d 100644
--- a/arch/sh/drivers/pci/pci-sh4.h
+++ b/arch/sh/drivers/pci/pci-sh4.h
@@ -167,13 +167,13 @@
static inline void pci_write_reg(struct pci_channel *chan,
unsigned long val, unsigned long reg)
{
- ctrl_outl(val, chan->reg_base + reg);
+ __raw_writel(val, chan->reg_base + reg);
}
static inline unsigned long pci_read_reg(struct pci_channel *chan,
unsigned long reg)
{
- return ctrl_inl(chan->reg_base + reg);
+ return __raw_readl(chan->reg_base + reg);
}
#endif /* __PCI_SH4_H */
diff --git a/arch/sh/drivers/pci/pci-sh5.h b/arch/sh/drivers/pci/pci-sh5.h
index f277628..3f01dec 100644
--- a/arch/sh/drivers/pci/pci-sh5.h
+++ b/arch/sh/drivers/pci/pci-sh5.h
@@ -86,14 +86,14 @@
/* #define PCISH5_VCR_REG(x) ( SH5PCI_VCR_BASE (PCISH5_VCR_##x)) */
/* Write I/O functions */
-#define SH5PCI_WRITE(reg,val) ctrl_outl((u32)(val),PCISH5_ICR_REG(reg))
-#define SH5PCI_WRITE_SHORT(reg,val) ctrl_outw((u16)(val),PCISH5_ICR_REG(reg))
-#define SH5PCI_WRITE_BYTE(reg,val) ctrl_outb((u8)(val),PCISH5_ICR_REG(reg))
+#define SH5PCI_WRITE(reg,val) __raw_writel((u32)(val),PCISH5_ICR_REG(reg))
+#define SH5PCI_WRITE_SHORT(reg,val) __raw_writew((u16)(val),PCISH5_ICR_REG(reg))
+#define SH5PCI_WRITE_BYTE(reg,val) __raw_writeb((u8)(val),PCISH5_ICR_REG(reg))
/* Read I/O functions */
-#define SH5PCI_READ(reg) ctrl_inl(PCISH5_ICR_REG(reg))
-#define SH5PCI_READ_SHORT(reg) ctrl_inw(PCISH5_ICR_REG(reg))
-#define SH5PCI_READ_BYTE(reg) ctrl_inb(PCISH5_ICR_REG(reg))
+#define SH5PCI_READ(reg) __raw_readl(PCISH5_ICR_REG(reg))
+#define SH5PCI_READ_SHORT(reg) __raw_readw(PCISH5_ICR_REG(reg))
+#define SH5PCI_READ_BYTE(reg) __raw_readb(PCISH5_ICR_REG(reg))
/* Set PCI config bits */
#define SET_CONFIG_BITS(bus,devfn,where) ((((bus) << 16) | ((devfn) << 8) | ((where) & ~3)) | 0x80000000)
diff --git a/arch/sh/drivers/pci/pci-sh7751.c b/arch/sh/drivers/pci/pci-sh7751.c
index 70c1999..2455cf3 100644
--- a/arch/sh/drivers/pci/pci-sh7751.c
+++ b/arch/sh/drivers/pci/pci-sh7751.c
@@ -97,9 +97,9 @@
return ret;
/* Set the BCR's to enable PCI access */
- reg = ctrl_inl(SH7751_BCR1);
+ reg = __raw_readl(SH7751_BCR1);
reg |= 0x80000;
- ctrl_outl(reg, SH7751_BCR1);
+ __raw_writel(reg, SH7751_BCR1);
/* Turn the clocks back on (not done in reset)*/
pci_write_reg(chan, 0, SH4_PCICLKR);
@@ -159,13 +159,13 @@
return -1;
/* configure the wait control registers */
- word = ctrl_inl(SH7751_WCR1);
+ word = __raw_readl(SH7751_WCR1);
pci_write_reg(chan, word, SH4_PCIWCR1);
- word = ctrl_inl(SH7751_WCR2);
+ word = __raw_readl(SH7751_WCR2);
pci_write_reg(chan, word, SH4_PCIWCR2);
- word = ctrl_inl(SH7751_WCR3);
+ word = __raw_readl(SH7751_WCR3);
pci_write_reg(chan, word, SH4_PCIWCR3);
- word = ctrl_inl(SH7751_MCR);
+ word = __raw_readl(SH7751_MCR);
pci_write_reg(chan, word, SH4_PCIMCR);
/* NOTE: I'm ignoring the PCI error IRQs for now..