[AVR32] leds-gpio for stk1000
Add GPIO led support: J2 to either block of LEDs on the STK1000.
This uses the new LEDS_GPIO driver, and sets up a heartbeat trigger by
default ... either bright (!!) amber, or a more interesting purple.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
diff --git a/arch/avr32/boards/atstk1000/Kconfig b/arch/avr32/boards/atstk1000/Kconfig
index 71bc7d3..718578f 100644
--- a/arch/avr32/boards/atstk1000/Kconfig
+++ b/arch/avr32/boards/atstk1000/Kconfig
@@ -50,4 +50,30 @@
GPIO lines and accessed through the J1 jumper block. Say "y"
here to configure that SPI controller.
+config BOARD_ATSTK1002_J2_LED
+ bool
+ default BOARD_ATSTK1002_J2_LED8 || BOARD_ATSTK1002_J2_RGB
+
+choice
+ prompt "LEDs connected to J2:"
+ depends on LEDS_GPIO && !BOARD_ATSTK1002_SW4_CUSTOM
+ optional
+ help
+ Select this if you have jumpered the J2 jumper block to the
+ LED0..LED7 amber leds, or to the RGB leds, using a ten-pin
+ IDC cable. A default "heartbeat" trigger is provided, but
+ you can of course override this.
+
+config BOARD_ATSTK1002_J2_LED8
+ bool "LED0..LED7"
+ help
+ Select this if J2 is jumpered to LED0..LED7 amber leds.
+
+config BOARD_ATSTK1002_J2_RGB
+ bool "RGB leds"
+ help
+ Select this if J2 is jumpered to the RGB leds.
+
+endchoice
+
endif # stk 1002