Blackfin: punt Blackfin-specific GPIO wakeup API
This patch removes a custom GPIO wakeup API which allowed GPIOs to act
as wakeup sources, which are not configured as Interrupts.
This API is a leftover from the time before irq_wake was established.
From now on people must use enable_irq_wake(GPIO_IRQx) and the GPIO in
question needs to be configured as Interrupt.
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/include/asm/gpio.h b/arch/blackfin/include/asm/gpio.h
index 91bd2d7..01b19d0 100644
--- a/arch/blackfin/include/asm/gpio.h
+++ b/arch/blackfin/include/asm/gpio.h
@@ -167,23 +167,23 @@
#endif
#ifdef CONFIG_PM
+int bfin_pm_standby_ctrl(unsigned ctrl);
-unsigned int bfin_pm_standby_setup(void);
-void bfin_pm_standby_restore(void);
+static inline int bfin_pm_standby_setup(void)
+{
+ return bfin_pm_standby_ctrl(1);
+}
+
+static inline void bfin_pm_standby_restore(void)
+{
+ bfin_pm_standby_ctrl(0);
+}
void bfin_gpio_pm_hibernate_restore(void);
void bfin_gpio_pm_hibernate_suspend(void);
#ifndef CONFIG_BF54x
-#define PM_WAKE_RISING 0x1
-#define PM_WAKE_FALLING 0x2
-#define PM_WAKE_HIGH 0x4
-#define PM_WAKE_LOW 0x8
-#define PM_WAKE_BOTH_EDGES (PM_WAKE_RISING | PM_WAKE_FALLING)
-#define PM_WAKE_IGNORE 0xF0
-
-int gpio_pm_wakeup_request(unsigned gpio, unsigned char type);
-void gpio_pm_wakeup_free(unsigned gpio);
+int gpio_pm_wakeup_ctrl(unsigned gpio, unsigned ctrl);
struct gpio_port_s {
unsigned short data;