IPoIB: Use dev_set_mtu() to change mtu
When the driver sets the MTU of the net device outside of its
change_mtu method, it should make use of dev_set_mtu() instead of
directly setting the mtu field of struct netdevice. Otherwise
functions registered to be called upon MTU change will not get called
(this is done through call_netdevice_notifiers() in dev_set_mtu()).
Signed-off-by: Eli Cohen <eli@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/ulp/ipoib/ipoib_cm.c b/drivers/infiniband/ulp/ipoib/ipoib_cm.c
index b426913..87f9f3e 100644
--- a/drivers/infiniband/ulp/ipoib/ipoib_cm.c
+++ b/drivers/infiniband/ulp/ipoib/ipoib_cm.c
@@ -1458,7 +1458,7 @@
if (priv->hca_caps & IB_DEVICE_UD_TSO)
dev->features |= NETIF_F_TSO;
}
- dev->mtu = min(priv->mcast_mtu, dev->mtu);
+ dev_set_mtu(dev, min(priv->mcast_mtu, dev->mtu));
rtnl_unlock();
ipoib_flush_paths(dev);
diff --git a/drivers/infiniband/ulp/ipoib/ipoib_multicast.c b/drivers/infiniband/ulp/ipoib/ipoib_multicast.c
index be1ed38..1fcc9a8 100644
--- a/drivers/infiniband/ulp/ipoib/ipoib_multicast.c
+++ b/drivers/infiniband/ulp/ipoib/ipoib_multicast.c
@@ -577,7 +577,7 @@
if (!ipoib_cm_admin_enabled(dev)) {
rtnl_lock();
- dev->mtu = min(priv->mcast_mtu, priv->admin_mtu);
+ dev_set_mtu(dev, min(priv->mcast_mtu, priv->admin_mtu));
rtnl_unlock();
}