SCSI: hpsa: fix handling of protocol error
commit 256d0eaac87da1e993190846064f339f4c7a63f5 upstream.
If a command status of CMD_PROTOCOL_ERR is received, this
information should be conveyed to the SCSI mid layer, not
dropped on the floor. CMD_PROTOCOL_ERR may be received
from the Smart Array for any commands destined for an external
RAID controller such as a P2000, or commands destined for tape
drives or CD/DVD-ROM drives, if for instance a cable is
disconnected. This mostly affects multipath configurations, as
disconnecting a cable on a non-multipath configuration is not
going to do anything good regardless of whether CMD_PROTOCOL_ERR
is handled correctly or not. Not handling CMD_PROTOCOL_ERR
correctly in a multipath configaration involving external RAID
controllers may cause data corruption, so this is quite a serious
bug. This bug should not normally cause a problem for direct
attached disk storage.
Signed-off-by: Stephen M. Cameron <scameron@beardog.cce.hp.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c
index 500e20d..7c49e0a 100644
--- a/drivers/scsi/hpsa.c
+++ b/drivers/scsi/hpsa.c
@@ -1264,8 +1264,9 @@
}
break;
case CMD_PROTOCOL_ERR:
+ cmd->result = DID_ERROR << 16;
dev_warn(&h->pdev->dev, "cp %p has "
- "protocol error \n", cp);
+ "protocol error\n", cp);
break;
case CMD_HARDWARE_ERR:
cmd->result = DID_ERROR << 16;