e1000e: log when swflag is cleared unexpectedly on ICH/PCH devices
Since EXTCNF_CTRL.SWFLAG (used in the ownership arbitration of shared
resources, e.g. the PHY shared between the s/w, f/w, and h/w clients)
can be cleared by any of those clients, log a debug message when
software attempts to clear it and it is already cleared unexpectedly.
And since the swflag is cleared by a hardware reset, the driver does
not need to do that, but the mutex acquired when the bit is set must
still be cleared.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/e1000e/ich8lan.c b/drivers/net/e1000e/ich8lan.c
index dcd5db5..dddd0b3 100644
--- a/drivers/net/e1000e/ich8lan.c
+++ b/drivers/net/e1000e/ich8lan.c
@@ -889,8 +889,13 @@
u32 extcnf_ctrl;
extcnf_ctrl = er32(EXTCNF_CTRL);
- extcnf_ctrl &= ~E1000_EXTCNF_CTRL_SWFLAG;
- ew32(EXTCNF_CTRL, extcnf_ctrl);
+
+ if (extcnf_ctrl & E1000_EXTCNF_CTRL_SWFLAG) {
+ extcnf_ctrl &= ~E1000_EXTCNF_CTRL_SWFLAG;
+ ew32(EXTCNF_CTRL, extcnf_ctrl);
+ } else {
+ e_dbg("Semaphore unexpectedly released by sw/fw/hw\n");
+ }
mutex_unlock(&swflag_mutex);
}
@@ -3066,7 +3071,7 @@
msleep(20);
if (!ret_val)
- e1000_release_swflag_ich8lan(hw);
+ mutex_unlock(&swflag_mutex);
if (ctrl & E1000_CTRL_PHY_RST) {
ret_val = hw->phy.ops.get_cfg_done(hw);