msm: 8930: enable charger, bms and ccadc
Enable charger for PM8038 platform and its dependent devices.
This is required to enable charging on devices using PM8038.
Also change gpio mux configuration to make sure that VBUS
is not pulled high when gpio_request is made.
Change-Id: Id64bc3846090bcaedf00f5f9177930618fa61605
Signed-off-by: David Keitel <dkeitel@codeaurora.org>
diff --git a/arch/arm/mach-msm/board-8930-gpiomux.c b/arch/arm/mach-msm/board-8930-gpiomux.c
index fc64ed2..84dbea8 100644
--- a/arch/arm/mach-msm/board-8930-gpiomux.c
+++ b/arch/arm/mach-msm/board-8930-gpiomux.c
@@ -156,29 +156,22 @@
.pull = GPIOMUX_PULL_DOWN,
};
#ifdef MSM8930_PHASE_2
-static struct gpiomux_setting hsusb_act_cfg = {
- .func = GPIOMUX_FUNC_GPIO,
- .drv = GPIOMUX_DRV_8MA,
- .pull = GPIOMUX_PULL_UP,
-};
-
static struct gpiomux_setting hsusb_sus_cfg = {
.func = GPIOMUX_FUNC_GPIO,
.drv = GPIOMUX_DRV_2MA,
- .pull = GPIOMUX_PULL_DOWN,
+ .pull = GPIOMUX_PULL_NONE,
+ .dir = GPIOMUX_OUT_LOW,
};
static struct msm_gpiomux_config msm8930_hsusb_configs[] = {
{
.gpio = 63, /* HSUSB_EXTERNAL_5V_LDO_EN */
.settings = {
- [GPIOMUX_ACTIVE] = &hsusb_act_cfg,
[GPIOMUX_SUSPENDED] = &hsusb_sus_cfg,
},
},
{
.gpio = 97, /* HSUSB_5V_EN */
.settings = {
- [GPIOMUX_ACTIVE] = &hsusb_act_cfg,
[GPIOMUX_SUSPENDED] = &hsusb_sus_cfg,
},
},