[PATCH] x86_64: On Intel CPUs don't do an additional CPU sync before RDTSC
RDTSC serialization using cpuid is not needed for Intel platforms.
This increases gettimeofday performance.
Cc: vojtech@suse.cz
Cc: rohit.seth@intel.com
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/arch/x86_64/kernel/time.c b/arch/x86_64/kernel/time.c
index f8d4b69..25bc58a 100644
--- a/arch/x86_64/kernel/time.c
+++ b/arch/x86_64/kernel/time.c
@@ -71,14 +71,6 @@
struct timespec __xtime __section_xtime;
struct timezone __sys_tz __section_sys_tz;
-static inline void rdtscll_sync(unsigned long *tsc)
-{
-#ifdef CONFIG_SMP
- sync_core();
-#endif
- rdtscll(*tsc);
-}
-
/*
* do_gettimeoffset() returns microseconds since last timer interrupt was
* triggered by hardware. A memory read of HPET is slower than a register read
@@ -93,7 +85,7 @@
{
unsigned long t;
unsigned long x;
- rdtscll_sync(&t);
+ t = get_cycles_sync();
if (t < vxtime.last_tsc) t = vxtime.last_tsc; /* hack */
x = ((t - vxtime.last_tsc) * vxtime.tsc_quot) >> 32;
return x;
@@ -309,8 +301,7 @@
last_offset = vxtime.last_tsc;
base = monotonic_base;
} while (read_seqretry(&xtime_lock, seq));
- sync_core();
- rdtscll(this_offset);
+ this_offset = get_cycles_sync();
offset = (this_offset - last_offset)*1000/cpu_khz;
return base + offset;
}
@@ -391,7 +382,7 @@
delay = LATCH - 1 - delay;
}
- rdtscll_sync(&tsc);
+ tsc = get_cycles_sync();
if (vxtime.mode == VXTIME_HPET) {
if (offset - vxtime.last > hpet_tick) {
@@ -700,8 +691,7 @@
do {
local_irq_disable();
hpet_now = hpet_readl(HPET_COUNTER);
- sync_core();
- rdtscl(tsc_now);
+ tsc_now = get_cycles_sync();
local_irq_restore(flags);
} while ((tsc_now - tsc_start) < TICK_COUNT &&
(hpet_now - hpet_start) < TICK_COUNT);
@@ -731,11 +721,9 @@
outb(0xb0, 0x43);
outb((PIT_TICK_RATE / (1000 / 50)) & 0xff, 0x42);
outb((PIT_TICK_RATE / (1000 / 50)) >> 8, 0x42);
- rdtscll(start);
- sync_core();
+ start = get_cycles_sync();
while ((inb(0x61) & 0x20) == 0);
- sync_core();
- rdtscll(end);
+ end = get_cycles_sync();
spin_unlock_irqrestore(&i8253_lock, flags);
@@ -939,7 +927,7 @@
vxtime.mode = VXTIME_TSC;
vxtime.quot = (1000000L << 32) / vxtime_hz;
vxtime.tsc_quot = (1000L << 32) / cpu_khz;
- rdtscll_sync(&vxtime.last_tsc);
+ vxtime.last_tsc = get_cycles_sync();
setup_irq(0, &irq0);
set_cyc2ns_scale(cpu_khz);