|  | /* | 
|  | * PMC-Sierra SPC 8001 SAS/SATA based host adapters driver | 
|  | * | 
|  | * Copyright (c) 2008-2009 USI Co., Ltd. | 
|  | * All rights reserved. | 
|  | * | 
|  | * Redistribution and use in source and binary forms, with or without | 
|  | * modification, are permitted provided that the following conditions | 
|  | * are met: | 
|  | * 1. Redistributions of source code must retain the above copyright | 
|  | *    notice, this list of conditions, and the following disclaimer, | 
|  | *    without modification. | 
|  | * 2. Redistributions in binary form must reproduce at minimum a disclaimer | 
|  | *    substantially similar to the "NO WARRANTY" disclaimer below | 
|  | *    ("Disclaimer") and any redistribution must be conditioned upon | 
|  | *    including a substantially similar Disclaimer requirement for further | 
|  | *    binary redistribution. | 
|  | * 3. Neither the names of the above-listed copyright holders nor the names | 
|  | *    of any contributors may be used to endorse or promote products derived | 
|  | *    from this software without specific prior written permission. | 
|  | * | 
|  | * Alternatively, this software may be distributed under the terms of the | 
|  | * GNU General Public License ("GPL") version 2 as published by the Free | 
|  | * Software Foundation. | 
|  | * | 
|  | * NO WARRANTY | 
|  | * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS | 
|  | * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT | 
|  | * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR | 
|  | * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT | 
|  | * HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL | 
|  | * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS | 
|  | * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) | 
|  | * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, | 
|  | * STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING | 
|  | * IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE | 
|  | * POSSIBILITY OF SUCH DAMAGES. | 
|  | * | 
|  | */ | 
|  |  | 
|  | #ifndef _PM8001_DEFS_H_ | 
|  | #define _PM8001_DEFS_H_ | 
|  |  | 
|  | enum chip_flavors { | 
|  | chip_8001, | 
|  | }; | 
|  | #define USI_MAX_MEMCNT			9 | 
|  | #define PM8001_MAX_DMA_SG		SG_ALL | 
|  | enum phy_speed { | 
|  | PHY_SPEED_15 = 0x01, | 
|  | PHY_SPEED_30 = 0x02, | 
|  | PHY_SPEED_60 = 0x04, | 
|  | }; | 
|  |  | 
|  | enum data_direction { | 
|  | DATA_DIR_NONE = 0x0,	/* NO TRANSFER */ | 
|  | DATA_DIR_IN = 0x01,	/* INBOUND */ | 
|  | DATA_DIR_OUT = 0x02,	/* OUTBOUND */ | 
|  | DATA_DIR_BYRECIPIENT = 0x04, /* UNSPECIFIED */ | 
|  | }; | 
|  |  | 
|  | enum port_type { | 
|  | PORT_TYPE_SAS = (1L << 1), | 
|  | PORT_TYPE_SATA = (1L << 0), | 
|  | }; | 
|  |  | 
|  | /* driver compile-time configuration */ | 
|  | #define	PM8001_MAX_CCB		 512	/* max ccbs supported */ | 
|  | #define	PM8001_MAX_INB_NUM	 1 | 
|  | #define	PM8001_MAX_OUTB_NUM	 1 | 
|  | #define	PM8001_CAN_QUEUE	 128	/* SCSI Queue depth */ | 
|  |  | 
|  | /* unchangeable hardware details */ | 
|  | #define	PM8001_MAX_PHYS		 8	/* max. possible phys */ | 
|  | #define	PM8001_MAX_PORTS	 8	/* max. possible ports */ | 
|  | #define	PM8001_MAX_DEVICES	 1024	/* max supported device */ | 
|  |  | 
|  | enum memory_region_num { | 
|  | AAP1 = 0x0, /* application acceleration processor */ | 
|  | IOP,	    /* IO processor */ | 
|  | CI,	    /* consumer index */ | 
|  | PI,	    /* producer index */ | 
|  | IB,	    /* inbound queue */ | 
|  | OB,	    /* outbound queue */ | 
|  | NVMD,	    /* NVM device */ | 
|  | DEV_MEM,    /* memory for devices */ | 
|  | CCB_MEM,    /* memory for command control block */ | 
|  | }; | 
|  | #define	PM8001_EVENT_LOG_SIZE	 (128 * 1024) | 
|  |  | 
|  | /*error code*/ | 
|  | enum mpi_err { | 
|  | MPI_IO_STATUS_SUCCESS = 0x0, | 
|  | MPI_IO_STATUS_BUSY = 0x01, | 
|  | MPI_IO_STATUS_FAIL = 0x02, | 
|  | }; | 
|  |  | 
|  | /** | 
|  | * Phy Control constants | 
|  | */ | 
|  | enum phy_control_type { | 
|  | PHY_LINK_RESET = 0x01, | 
|  | PHY_HARD_RESET = 0x02, | 
|  | PHY_NOTIFY_ENABLE_SPINUP = 0x10, | 
|  | }; | 
|  |  | 
|  | enum pm8001_hba_info_flags { | 
|  | PM8001F_INIT_TIME	= (1U << 0), | 
|  | PM8001F_RUN_TIME	= (1U << 1), | 
|  | }; | 
|  |  | 
|  | #endif |