[SCSI] bnx2fc: Clear DESTROY_CMPL flag after firmware destroy
Since this flag was never cleared, the driver does not wait for firmware
destroy completions, causing missed KCQEs.
Signed-off-by: Bhanu Prakash Gollapudi <bprakash@broadcom.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/bnx2fc/bnx2fc_fcoe.c b/drivers/scsi/bnx2fc/bnx2fc_fcoe.c
index dccabaf..ca2e206 100644
--- a/drivers/scsi/bnx2fc/bnx2fc_fcoe.c
+++ b/drivers/scsi/bnx2fc/bnx2fc_fcoe.c
@@ -771,8 +771,8 @@
{
struct bnx2fc_hba *hba = (struct bnx2fc_hba *)data;
- BNX2FC_MISC_DBG("ERROR:bnx2fc_destroy_timer - "
- "Destroy compl not received!!\n");
+ printk(KERN_ERR PFX "ERROR:bnx2fc_destroy_timer - "
+ "Destroy compl not received!!\n");
set_bit(BNX2FC_FLAG_DESTROY_CMPL, &hba->flags);
wake_up_interruptible(&hba->destroy_wait);
}
@@ -1701,6 +1701,7 @@
wait_event_interruptible(hba->destroy_wait,
test_bit(BNX2FC_FLAG_DESTROY_CMPL,
&hba->flags));
+ clear_bit(BNX2FC_FLAG_DESTROY_CMPL, &hba->flags);
/* This should never happen */
if (signal_pending(current))
flush_signals(current);