| IBM ServeRAID driver Change Log |
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ |
| |
| 5.00.01 - Sarasota ( 5i ) adapters must always be scanned first |
| - Get rid on IOCTL_NEW_COMMAND code |
| - Add Extended DCDB Commands for Tape Support in 5I |
| |
| 4.90.11 - Don't actually RESET unless it's physically required |
| - Remove unused compile options |
| |
| 4.90.08 - Data Corruption if First Scatter Gather Element is > 64K |
| |
| 4.90.08 - Increase Delays in Flashing ( Trombone Only - 4H ) |
| |
| 4.90.05 - Use New PCI Architecture to facilitate Hot Plug Development |
| |
| 4.90.01 - Add ServeRAID Version Checking |
| |
| 4.80.26 - Clean up potential code problems ( Arjan's recommendations ) |
| |
| 4.80.21 - Change memcpy() to copy_to_user() in NVRAM Page 5 IOCTL path |
| |
| 4.80.20 - Set max_sectors in Scsi_Host structure ( if >= 2.4.7 kernel ) |
| - 5 second delay needed after resetting an i960 adapter |
| |
| 4.80.14 - Take all semaphores off stack |
| - Clean Up New_IOCTL path |
| |
| 4.80.04 - Eliminate calls to strtok() if 2.4.x or greater |
| - Adjustments to Device Queue Depth |
| |
| 4.80.00 - Make ia64 Safe |
| |
| 4.72.01 - I/O Mapped Memory release ( so "insmod ips" does not Fail ) |
| - Don't Issue Internal FFDC Command if there are Active Commands |
| - Close Window for getting too many IOCTL's active |
| |
| 4.72.00 - Allow for a Scatter-Gather Element to exceed MAX_XFER Size |
| |
| 4.71.00 - Change all memory allocations to not use GFP_DMA flag |
| - Code Clean-Up for 2.4.x kernel |
| |
| 4.70.15 - Fix Breakup for very large ( non-SG ) requests |
| |
| 4.70.13 - Don't release HA Lock in ips_next() until SC taken off queue |
| - Unregister SCSI device in ips_release() |
| - Don't Send CDB's if we already know the device is not present |
| |
| 4.70.12 - Corrective actions for bad controller ( during initialization ) |
| |
| 4.70.09 - Use a Common ( Large Buffer ) for Flashing from the JCRM CD |
| - Add IPSSEND Flash Support |
| - Set Sense Data for Unknown SCSI Command |
| - Use Slot Number from NVRAM Page 5 |
| - Restore caller's DCDB Structure |
| |
| 4.20.14 - Update patch files for kernel 2.4.0-test5 |
| |
| 4.20.13 - Fix some failure cases / reset code |
| - Hook into the reboot_notifier to flush the controller |
| cache |
| |
| 4.20.03 - Rename version to coincide with new release schedules |
| - Performance fixes |
| - Fix truncation of /proc files with cat |
| - Merge in changes through kernel 2.4.0test1ac21 |
| |
| 4.10.13 - Fix for dynamic unload and proc file system |
| |
| 4.10.00 - Add support for ServeRAID 4M/4L |
| |
| 4.00.06 - Fix timeout with initial FFDC command |
| |
| 4.00.05 - Remove wish_block from init routine |
| - Use linux/spinlock.h instead of asm/spinlock.h for kernels |
| 2.3.18 and later |
| - Sync with other changes from the 2.3 kernels |
| |
| 4.00.04 - Rename structures/constants to be prefixed with IPS_ |
| |
| 4.00.03 - Add alternative passthru interface |
| - Add ability to flash ServeRAID BIOS |
| |
| 4.00.02 - Fix problem with PT DCDB with no buffer |
| |
| 4.00.01 - Add support for First Failure Data Capture |
| |
| 4.00.00 - Add support for ServeRAID 4 |
| |
| 3.60.02 - Make DCDB direction based on lookup table. |
| - Only allow one DCDB command to a SCSI ID at a time. |
| |
| 3.60.01 - Remove bogus error check in passthru routine. |
| |
| 3.60.00 - Bump max commands to 128 for use with ServeRAID |
| firmware 3.60. |
| - Change version to 3.60 to coincide with ServeRAID release |
| numbering. |
| |
| 1.00.00 - Initial Public Release |
| - Functionally equivalent to 0.99.05 |
| |
| 0.99.05 - Fix an oops on certain passthru commands |
| |
| 0.99.04 - Fix race condition in the passthru mechanism |
| -- this required the interface to the utilities to change |
| - Fix error recovery code |
| |
| 0.99.03 - Make interrupt routine handle all completed request on the |
| adapter not just the first one |
| - Make sure passthru commands get woken up if we run out of |
| SCBs |
| - Send all of the commands on the queue at once rather than |
| one at a time since the card will support it. |
| |
| 0.99.02 - Added some additional debug statements to print out |
| errors if an error occurs while trying to read/write |
| to a logical drive (IPS_DEBUG). |
| |
| - Fixed read/write errors when the adapter is using an |
| 8K stripe size. |
| |