|  | /* | 
|  | * arch/arm/mach-pxa/time.c | 
|  | * | 
|  | * Author:	Nicolas Pitre | 
|  | * Created:	Jun 15, 2001 | 
|  | * Copyright:	MontaVista Software Inc. | 
|  | * | 
|  | * This program is free software; you can redistribute it and/or modify | 
|  | * it under the terms of the GNU General Public License version 2 as | 
|  | * published by the Free Software Foundation. | 
|  | */ | 
|  |  | 
|  | #include <linux/kernel.h> | 
|  | #include <linux/init.h> | 
|  | #include <linux/delay.h> | 
|  | #include <linux/interrupt.h> | 
|  | #include <linux/time.h> | 
|  | #include <linux/signal.h> | 
|  | #include <linux/errno.h> | 
|  | #include <linux/sched.h> | 
|  | #include <linux/clocksource.h> | 
|  |  | 
|  | #include <asm/system.h> | 
|  | #include <asm/hardware.h> | 
|  | #include <asm/io.h> | 
|  | #include <asm/leds.h> | 
|  | #include <asm/irq.h> | 
|  | #include <asm/mach/irq.h> | 
|  | #include <asm/mach/time.h> | 
|  | #include <asm/arch/pxa-regs.h> | 
|  |  | 
|  |  | 
|  | static inline unsigned long pxa_get_rtc_time(void) | 
|  | { | 
|  | return RCNR; | 
|  | } | 
|  |  | 
|  | static int pxa_set_rtc(void) | 
|  | { | 
|  | unsigned long current_time = xtime.tv_sec; | 
|  |  | 
|  | if (RTSR & RTSR_ALE) { | 
|  | /* make sure not to forward the clock over an alarm */ | 
|  | unsigned long alarm = RTAR; | 
|  | if (current_time >= alarm && alarm >= RCNR) | 
|  | return -ERESTARTSYS; | 
|  | } | 
|  | RCNR = current_time; | 
|  | return 0; | 
|  | } | 
|  |  | 
|  | #ifdef CONFIG_NO_IDLE_HZ | 
|  | static unsigned long initial_match; | 
|  | static int match_posponed; | 
|  | #endif | 
|  |  | 
|  | static irqreturn_t | 
|  | pxa_timer_interrupt(int irq, void *dev_id) | 
|  | { | 
|  | int next_match; | 
|  |  | 
|  | write_seqlock(&xtime_lock); | 
|  |  | 
|  | #ifdef CONFIG_NO_IDLE_HZ | 
|  | if (match_posponed) { | 
|  | match_posponed = 0; | 
|  | OSMR0 = initial_match; | 
|  | } | 
|  | #endif | 
|  |  | 
|  | /* Loop until we get ahead of the free running timer. | 
|  | * This ensures an exact clock tick count and time accuracy. | 
|  | * Since IRQs are disabled at this point, coherence between | 
|  | * lost_ticks(updated in do_timer()) and the match reg value is | 
|  | * ensured, hence we can use do_gettimeofday() from interrupt | 
|  | * handlers. | 
|  | * | 
|  | * HACK ALERT: it seems that the PXA timer regs aren't updated right | 
|  | * away in all cases when a write occurs.  We therefore compare with | 
|  | * 8 instead of 0 in the while() condition below to avoid missing a | 
|  | * match if OSCR has already reached the next OSMR value. | 
|  | * Experience has shown that up to 6 ticks are needed to work around | 
|  | * this problem, but let's use 8 to be conservative.  Note that this | 
|  | * affect things only when the timer IRQ has been delayed by nearly | 
|  | * exactly one tick period which should be a pretty rare event. | 
|  | */ | 
|  | do { | 
|  | timer_tick(); | 
|  | OSSR = OSSR_M0;  /* Clear match on timer 0 */ | 
|  | next_match = (OSMR0 += LATCH); | 
|  | } while( (signed long)(next_match - OSCR) <= 8 ); | 
|  |  | 
|  | write_sequnlock(&xtime_lock); | 
|  |  | 
|  | return IRQ_HANDLED; | 
|  | } | 
|  |  | 
|  | static struct irqaction pxa_timer_irq = { | 
|  | .name		= "PXA Timer Tick", | 
|  | .flags		= IRQF_DISABLED | IRQF_TIMER, | 
|  | .handler	= pxa_timer_interrupt, | 
|  | }; | 
|  |  | 
|  | static cycle_t pxa_get_cycles(void) | 
|  | { | 
|  | return OSCR; | 
|  | } | 
|  |  | 
|  | static struct clocksource clocksource_pxa = { | 
|  | .name           = "pxa_timer", | 
|  | .rating         = 200, | 
|  | .read           = pxa_get_cycles, | 
|  | .mask           = CLOCKSOURCE_MASK(32), | 
|  | .shift          = 20, | 
|  | .flags		= CLOCK_SOURCE_IS_CONTINUOUS, | 
|  | }; | 
|  |  | 
|  | static void __init pxa_timer_init(void) | 
|  | { | 
|  | struct timespec tv; | 
|  | unsigned long flags; | 
|  |  | 
|  | set_rtc = pxa_set_rtc; | 
|  |  | 
|  | tv.tv_nsec = 0; | 
|  | tv.tv_sec = pxa_get_rtc_time(); | 
|  | do_settimeofday(&tv); | 
|  |  | 
|  | OIER = 0;		/* disable any timer interrupts */ | 
|  | OSSR = 0xf;		/* clear status on all timers */ | 
|  | setup_irq(IRQ_OST0, &pxa_timer_irq); | 
|  | local_irq_save(flags); | 
|  | OIER = OIER_E0;		/* enable match on timer 0 to cause interrupts */ | 
|  | OSMR0 = OSCR + LATCH;	/* set initial match */ | 
|  | local_irq_restore(flags); | 
|  |  | 
|  | /* | 
|  | * OSCR runs continuously on PXA and is not written to, | 
|  | * so we can use it as clock source directly. | 
|  | */ | 
|  | clocksource_pxa.mult = | 
|  | clocksource_hz2mult(CLOCK_TICK_RATE, clocksource_pxa.shift); | 
|  | clocksource_register(&clocksource_pxa); | 
|  | } | 
|  |  | 
|  | #ifdef CONFIG_NO_IDLE_HZ | 
|  | static int pxa_dyn_tick_enable_disable(void) | 
|  | { | 
|  | /* nothing to do */ | 
|  | return 0; | 
|  | } | 
|  |  | 
|  | static void pxa_dyn_tick_reprogram(unsigned long ticks) | 
|  | { | 
|  | if (ticks > 1) { | 
|  | initial_match = OSMR0; | 
|  | OSMR0 = initial_match + ticks * LATCH; | 
|  | match_posponed = 1; | 
|  | } | 
|  | } | 
|  |  | 
|  | static irqreturn_t | 
|  | pxa_dyn_tick_handler(int irq, void *dev_id) | 
|  | { | 
|  | if (match_posponed) { | 
|  | match_posponed = 0; | 
|  | OSMR0 = initial_match; | 
|  | if ( (signed long)(initial_match - OSCR) <= 8 ) | 
|  | return pxa_timer_interrupt(irq, dev_id); | 
|  | } | 
|  | return IRQ_NONE; | 
|  | } | 
|  |  | 
|  | static struct dyn_tick_timer pxa_dyn_tick = { | 
|  | .enable		= pxa_dyn_tick_enable_disable, | 
|  | .disable	= pxa_dyn_tick_enable_disable, | 
|  | .reprogram	= pxa_dyn_tick_reprogram, | 
|  | .handler	= pxa_dyn_tick_handler, | 
|  | }; | 
|  | #endif | 
|  |  | 
|  | #ifdef CONFIG_PM | 
|  | static unsigned long osmr[4], oier; | 
|  |  | 
|  | static void pxa_timer_suspend(void) | 
|  | { | 
|  | osmr[0] = OSMR0; | 
|  | osmr[1] = OSMR1; | 
|  | osmr[2] = OSMR2; | 
|  | osmr[3] = OSMR3; | 
|  | oier = OIER; | 
|  | } | 
|  |  | 
|  | static void pxa_timer_resume(void) | 
|  | { | 
|  | OSMR0 = osmr[0]; | 
|  | OSMR1 = osmr[1]; | 
|  | OSMR2 = osmr[2]; | 
|  | OSMR3 = osmr[3]; | 
|  | OIER = oier; | 
|  |  | 
|  | /* | 
|  | * OSMR0 is the system timer: make sure OSCR is sufficiently behind | 
|  | */ | 
|  | OSCR = OSMR0 - LATCH; | 
|  | } | 
|  | #else | 
|  | #define pxa_timer_suspend NULL | 
|  | #define pxa_timer_resume NULL | 
|  | #endif | 
|  |  | 
|  | struct sys_timer pxa_timer = { | 
|  | .init		= pxa_timer_init, | 
|  | .suspend	= pxa_timer_suspend, | 
|  | .resume		= pxa_timer_resume, | 
|  | #ifdef CONFIG_NO_IDLE_HZ | 
|  | .dyn_tick	= &pxa_dyn_tick, | 
|  | #endif | 
|  | }; |