[ARM] 4143/1: AT91: Prepare for AT91SAM9263 support
The Atmel AT91SAM9263 processor includes many more integrated
peripherals than Atmel's previous ARM9-based AT91 processors, so this
has necessitated a few changes to the core AT91 support.
These changes are:
* The system peripheral I/O region we remap has increased from
0xFFFA0000..0xFFFFFFFF to 0xFFF78000..0xFFFFFFFF.
* The increased I/O region forces changes to entry-macro.S and
debug-macro.S due to ARM's limited immediate offset addressing
modes.
* Maximum number of GPIO banks increases to 5.
* 2 MMC controllers so the board-setup code needs to specify which
controller it wishes to use when calling at91_add_device_mmc().
Original patch from Nicolas Ferre.
Signed-off-by: Andrew Victor <andrew@sanpeople.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/include/asm-arm/arch-at91/entry-macro.S b/include/asm-arm/arch-at91/entry-macro.S
index a6f3383..76c8ccc 100644
--- a/include/asm-arm/arch-at91/entry-macro.S
+++ b/include/asm-arm/arch-at91/entry-macro.S
@@ -17,10 +17,10 @@
.endm
.macro get_irqnr_and_base, irqnr, irqstat, base, tmp
- ldr \base, =(AT91_VA_BASE_SYS) @ base virtual address of SYS peripherals
- ldr \irqnr, [\base, #AT91_AIC_IVR] @ read IRQ vector register: de-asserts nIRQ to processor (and clears interrupt)
- ldr \irqstat, [\base, #AT91_AIC_ISR] @ read interrupt source number
- teq \irqstat, #0 @ ISR is 0 when no current interrupt, or spurious interrupt
- streq \tmp, [\base, #AT91_AIC_EOICR] @ not going to be handled further, then ACK it now.
+ ldr \base, =(AT91_VA_BASE_SYS + AT91_AIC) @ base virtual address of AIC peripheral
+ ldr \irqnr, [\base, #(AT91_AIC_IVR - AT91_AIC)] @ read IRQ vector register: de-asserts nIRQ to processor (and clears interrupt)
+ ldr \irqstat, [\base, #(AT91_AIC_ISR - AT91_AIC)] @ read interrupt source number
+ teq \irqstat, #0 @ ISR is 0 when no current interrupt, or spurious interrupt
+ streq \tmp, [\base, #(AT91_AIC_EOICR - AT91_AIC)] @ not going to be handled further, then ACK it now.
.endm