mtd: NOR flash driver for OMAP-L137/AM17x
OMAP-L137/AM17x has limited number of dedicated EMIFA
address pins, enough to interface directly to an SDRAM.
If a device such as an asynchronous flash needs to be
attached to the EMIFA, then either GPIO pins or a chip
select may be used to control the flash device's upper
address lines.
This patch adds support for the NOR flash on the OMAP-L137/
AM17x user interface daughter board using the latch-addr-flash
MTD mapping driver which allows flashes to be partially
physically addressed. The upper address lines are set by
a board specific code which is a separate patch.
Signed-off-by: David Griego <dgriego@mvista.com>
Signed-off-by: Aleksey Makarov <amakarov@ru.mvista.com>
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Savinay Dharmappa <savinay.dharmappa@ti.com>
Signed-off-by: Artem Bityutskiy <Artem.Bityutskiy@nokia.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/maps/Kconfig b/drivers/mtd/maps/Kconfig
index 803072a..44b1f46 100644
--- a/drivers/mtd/maps/Kconfig
+++ b/drivers/mtd/maps/Kconfig
@@ -552,4 +552,13 @@
When built as a module, it will be called pismo.ko
+config MTD_LATCH_ADDR
+ tristate "Latch-assisted Flash Chip Support"
+ depends on MTD_COMPLEX_MAPPINGS
+ help
+ Map driver which allows flashes to be partially physically addressed
+ and have the upper address lines set by a board specific code.
+
+ If compiled as a module, it will be called latch-addr-flash.
+
endmenu