sh: use ctrl_in/out for on chip pci access
This patch makes sure ctrl_inN/outN are used instead of inN/outN for on chip
pci registers. Without this patch addresses may be adjusted using the value
in generic_io_base. This patch makes it possible to set generic_io_base and
have pci without reading and writing all over the place.
Signed-off-by: Magnus Damm <damm@igel.co.jp>
Acked-by: Katsuya MATSUBARA <matsu@igel.co.jp>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/arch/sh/drivers/pci/fixups-lboxre2.c b/arch/sh/drivers/pci/fixups-lboxre2.c
index 40b19bd..1c1d412 100644
--- a/arch/sh/drivers/pci/fixups-lboxre2.c
+++ b/arch/sh/drivers/pci/fixups-lboxre2.c
@@ -18,7 +18,7 @@
{
unsigned long bcr1, mcr;
- bcr1 = inl(SH7751_BCR1);
+ bcr1 = ctrl_inl(SH7751_BCR1);
bcr1 |= 0x40080000; /* Enable Bit 19 BREQEN, set PCIC to slave */
pci_write_reg(bcr1, SH4_PCIBCR1);
@@ -28,7 +28,7 @@
pci_write_reg(0xfb900047, SH7751_PCICONF1);
pci_write_reg(0xab000001, SH7751_PCICONF4);
- mcr = inl(SH7751_MCR);
+ mcr = ctrl_inl(SH7751_MCR);
mcr = (mcr & PCIMCR_MRSET_OFF) & PCIMCR_RFSH_OFF;
pci_write_reg(mcr, SH4_PCIMCR);