wl12xx: use dynamic rate policies
allocate the rate policies dynamically, instead of using hardcoded
indexes. this is needed for proper multi-role configuration.
Signed-off-by: Eliad Peller <eliad@wizery.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>
diff --git a/drivers/net/wireless/wl12xx/acx.c b/drivers/net/wireless/wl12xx/acx.c
index 21e74ca..e2e4670 100644
--- a/drivers/net/wireless/wl12xx/acx.c
+++ b/drivers/net/wireless/wl12xx/acx.c
@@ -766,7 +766,7 @@
wlvif->basic_rate, wlvif->rate_set);
/* configure one basic rate class */
- acx->rate_policy_idx = cpu_to_le32(ACX_TX_BASIC_RATE);
+ acx->rate_policy_idx = cpu_to_le32(wlvif->sta.basic_rate_idx);
acx->rate_policy.enabled_rates = cpu_to_le32(wlvif->basic_rate);
acx->rate_policy.short_retry_limit = c->short_retry_limit;
acx->rate_policy.long_retry_limit = c->long_retry_limit;
@@ -779,7 +779,7 @@
}
/* configure one AP supported rate class */
- acx->rate_policy_idx = cpu_to_le32(ACX_TX_AP_FULL_RATE);
+ acx->rate_policy_idx = cpu_to_le32(wlvif->sta.ap_rate_idx);
acx->rate_policy.enabled_rates = cpu_to_le32(wlvif->rate_set);
acx->rate_policy.short_retry_limit = c->short_retry_limit;
acx->rate_policy.long_retry_limit = c->long_retry_limit;
@@ -796,7 +796,7 @@
* (p2p packets should always go out with OFDM rates, even
* if we are currently connected to 11b AP)
*/
- acx->rate_policy_idx = cpu_to_le32(ACX_TX_BASIC_RATE_P2P);
+ acx->rate_policy_idx = cpu_to_le32(wlvif->sta.p2p_rate_idx);
acx->rate_policy.enabled_rates =
cpu_to_le32(CONF_TX_RATE_MASK_BASIC_P2P);
acx->rate_policy.short_retry_limit = c->short_retry_limit;