pcmcia: move Vpp setup to struct pcmcia_device
Some drivers prefer to explicitly set Vpp. Instead of passing the
voltage inside config_req_t, store it in struct pcmcia_device.
CC: linux-ide@vger.kernel.org
CC: netdev@vger.kernel.org
CC: linux-mtd@lists.infradead.org
CC: linux-wireless@vger.kernel.org
CC: linux-serial@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: linux-scsi@vger.kernel.org
Acked-by: Gustavo F. Padovan <padovan@profusion.mobi> (for drivers/bluetooth)
Tested-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/ata/pata_pcmcia.c b/drivers/ata/pata_pcmcia.c
index e944aa0..12cdc9f 100644
--- a/drivers/ata/pata_pcmcia.c
+++ b/drivers/ata/pata_pcmcia.c
@@ -194,9 +194,9 @@
}
if (cfg->vpp1.present & (1 << CISTPL_POWER_VNOM))
- pdev->conf.Vpp = cfg->vpp1.param[CISTPL_POWER_VNOM] / 10000;
+ pdev->vpp = cfg->vpp1.param[CISTPL_POWER_VNOM] / 10000;
else if (dflt->vpp1.present & (1 << CISTPL_POWER_VNOM))
- pdev->conf.Vpp = dflt->vpp1.param[CISTPL_POWER_VNOM] / 10000;
+ pdev->vpp = dflt->vpp1.param[CISTPL_POWER_VNOM] / 10000;
if ((cfg->io.nwin > 0) || (dflt->io.nwin > 0)) {
cistpl_io_t *io = (cfg->io.nwin) ? &cfg->io : &dflt->io;