iwlwifi: remove noise reporting
We go to great lengths to calculate this value
that is never used by mac80211. Additionally,
it is now deprecated by mac80211 and is causing
driver compilation to give warnings.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Reinette Chatre <reinette.chatre@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn-lib.c b/drivers/net/wireless/iwlwifi/iwl-agn-lib.c
index 226862d..e8e3118 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn-lib.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn-lib.c
@@ -1071,30 +1071,14 @@
/* Find max signal strength (dBm) among 3 antenna/receiver chains */
rx_status.signal = iwlagn_calc_rssi(priv, phy_res);
- /* Meaningful noise values are available only from beacon statistics,
- * which are gathered only when associated, and indicate noise
- * only for the associated network channel ...
- * Ignore these noise values while scanning (other channels) */
- if (iwl_is_associated(priv) &&
- !test_bit(STATUS_SCANNING, &priv->status)) {
- rx_status.noise = priv->last_rx_noise;
- } else {
- rx_status.noise = IWL_NOISE_MEAS_NOT_AVAILABLE;
- }
-
- /* Reset beacon noise level if not associated. */
- if (!iwl_is_associated(priv))
- priv->last_rx_noise = IWL_NOISE_MEAS_NOT_AVAILABLE;
-
#ifdef CONFIG_IWLWIFI_DEBUG
/* Set "1" to report good data frames in groups of 100 */
if (unlikely(iwl_get_debug_level(priv) & IWL_DL_RX))
iwlagn_dbg_report_frame(priv, phy_res, len, header, 1);
#endif
iwl_dbg_log_rx_data_frame(priv, len, header);
- IWL_DEBUG_STATS_LIMIT(priv, "Rssi %d, noise %d, TSF %llu\n",
- rx_status.signal, rx_status.noise,
- (unsigned long long)rx_status.mactime);
+ IWL_DEBUG_STATS_LIMIT(priv, "Rssi %d, TSF %llu\n",
+ rx_status.signal, (unsigned long long)rx_status.mactime);
/*
* "antenna number"