libertas: Extend MESH_CONFIG command to access non-volatile configuration
This patch is based on a patch from Shailendra Govardhan and Brian Cavagnolo.
It extends the MESH_CONFIG command to configure non-volatile parameters on
libertas devices that support them (e.g. OLPC Active Antenna).
This patch only implements the driver/firmware interface.
See http://dev.laptop.org/ticket/6823 for minimal testing results and known
issues.
Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/libertas/assoc.c b/drivers/net/wireless/libertas/assoc.c
index c9c3640..953a44f 100644
--- a/drivers/net/wireless/libertas/assoc.c
+++ b/drivers/net/wireless/libertas/assoc.c
@@ -603,7 +603,8 @@
/* Change mesh channel first; 21.p21 firmware won't let
you change channel otherwise (even though it'll return
an error to this */
- lbs_mesh_config(priv, 0, assoc_req->channel);
+ lbs_mesh_config(priv, CMD_ACT_MESH_CONFIG_STOP,
+ assoc_req->channel);
}
lbs_deb_assoc("ASSOC: channel: %d -> %d\n",
@@ -642,7 +643,8 @@
restore_mesh:
if (priv->mesh_dev)
- lbs_mesh_config(priv, 1, priv->curbssparams.channel);
+ lbs_mesh_config(priv, CMD_ACT_MESH_CONFIG_START,
+ priv->curbssparams.channel);
done:
lbs_deb_leave_args(LBS_DEB_ASSOC, "ret %d", ret);