libertas: Extend MESH_CONFIG command to access non-volatile configuration
This patch is based on a patch from Shailendra Govardhan and Brian Cavagnolo.
It extends the MESH_CONFIG command to configure non-volatile parameters on
libertas devices that support them (e.g. OLPC Active Antenna).
This patch only implements the driver/firmware interface.
See http://dev.laptop.org/ticket/6823 for minimal testing results and known
issues.
Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/libertas/host.h b/drivers/net/wireless/libertas/host.h
index 3915c31..c92e41b 100644
--- a/drivers/net/wireless/libertas/host.h
+++ b/drivers/net/wireless/libertas/host.h
@@ -256,6 +256,23 @@
CMD_ACT_MESH_GET_AUTOSTART_ENABLED,
};
+/* Define actions and types for CMD_MESH_CONFIG */
+enum cmd_mesh_config_actions {
+ CMD_ACT_MESH_CONFIG_STOP = 0,
+ CMD_ACT_MESH_CONFIG_START,
+ CMD_ACT_MESH_CONFIG_SET,
+ CMD_ACT_MESH_CONFIG_GET,
+};
+
+enum cmd_mesh_config_types {
+ CMD_TYPE_MESH_SET_BOOTFLAG = 1,
+ CMD_TYPE_MESH_SET_BOOTTIME,
+ CMD_TYPE_MESH_SET_DEF_CHANNEL,
+ CMD_TYPE_MESH_SET_MESH_IE,
+ CMD_TYPE_MESH_GET_DEFAULTS,
+ CMD_TYPE_MESH_GET_MESH_IE, /* GET_DEFAULTS is superset of GET_MESHIE */
+};
+
/** Card Event definition */
#define MACREG_INT_CODE_TX_PPA_FREE 0
#define MACREG_INT_CODE_TX_DMA_DONE 1