Blackfin: BF518F-EZBRD: handle required portmuxing of async pins
The two high address lines on the BF51x are not dedicated which means we
need to handle them like any other peripheral pin if we want to access the
upper 2MB of parallel flash.
Signed-off-by: Graf Yang <graf.yang@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/mach-bf518/boards/ezbrd.c b/arch/blackfin/mach-bf518/boards/ezbrd.c
index 41f2eac..602dce0 100644
--- a/arch/blackfin/mach-bf518/boards/ezbrd.c
+++ b/arch/blackfin/mach-bf518/boards/ezbrd.c
@@ -82,7 +82,11 @@
static struct resource ezbrd_flash_resource = {
.start = 0x20000000,
+#if defined(CONFIG_SPI_BFIN) || defined(CONFIG_SPI_BFIN_MODULE)
+ .end = 0x202fffff,
+#else
.end = 0x203fffff,
+#endif
.flags = IORESOURCE_MEM,
};
@@ -678,6 +682,11 @@
ARRAY_SIZE(bfin_i2c_board_info));
platform_add_devices(stamp_devices, ARRAY_SIZE(stamp_devices));
spi_register_board_info(bfin_spi_board_info, ARRAY_SIZE(bfin_spi_board_info));
+ /* setup BF518-EZBRD GPIO pin PG11 to AMS2, PG15 to AMS3. */
+ peripheral_request(P_AMS2, "ParaFlash");
+#if !defined(CONFIG_SPI_BFIN) && !defined(CONFIG_SPI_BFIN_MODULE)
+ peripheral_request(P_AMS3, "ParaFlash");
+#endif
return 0;
}