net: Add ndo_{set|get}_vf_port support for enic dynamic vnics
Add enic ndo_{set|get}_vf_port ops to support setting/getting
port-profile for enic dynamic devices. Enic dynamic devices are just like
normal enic eth devices except dynamic enics require an extra configuration
step to assign a port-profile identifier to the interface before the
interface is useable. Once a port-profile is assigned, link comes up on the
interface and is ready for I/O. The port-profile is used to configure the
network port assigned to the interface. The network port configuration
includes VLAN membership, QoS policies, and port security settings typical
of a data center network.
A dynamic enic initially has a zero-mac address. Before a port-profile is
assigned, a valid non-zero unicast mac address should be assign to the
dynamic enic interface.
Signed-off-by: Scott Feldman <scofeldm@cisco.com>
Signed-off-by: Roopa Prabhu <roprabhu@cisco.com>
diff --git a/drivers/net/enic/Makefile b/drivers/net/enic/Makefile
index 391c3bc..e7b6c31 100644
--- a/drivers/net/enic/Makefile
+++ b/drivers/net/enic/Makefile
@@ -1,5 +1,5 @@
obj-$(CONFIG_ENIC) := enic.o
enic-y := enic_main.o vnic_cq.o vnic_intr.o vnic_wq.o \
- enic_res.o vnic_dev.o vnic_rq.o
+ enic_res.o vnic_dev.o vnic_rq.o vnic_vic.o